Tyr is a monoblock power amplifier from Schiit Audio, designed by the company's co-founder Jason Stoddard. The current version is sold as Tyr F, which Schiit calls a Nexus and Continuity choke-input monoblock amplifier. Chassis and transformers are made in California, the circuit boards come from Schiit's own line in Corpus Christi, and assembly takes place in San Antonio, Texas. A stereo system needs two units. The list price is USD 1,649 - 1,749 per unit, depending on the Forkbeard option, and the warranty is 5 years on parts and labour.
Key specs that matter
Output power is 200 W RMS into 8 ohms and 350 W RMS into 4 ohms. Frequency response is 20 Hz - 20 kHz (-0.1 dB) and 3 Hz - 500 kHz (-3 dB). THD is below 0.01% (20 Hz - 20 kHz, 200 W RMS into 8 ohms), and CCIR IMD is below 0.01% under the same load. Signal-to-noise ratio is above 120 dB (A-weighted, referenced to full output). Damping factor exceeds 200 into 8 ohms across 20 Hz - 20 kHz. Gain is 22 (28 dB), and input sensitivity is about 1.8 V. Input impedance is 47 kohms on both the single-ended and the balanced input. Each unit measures 406 x 330 x 98 mm (W x D x H) and weighs 25 kg.
Engineering and use context
Its gain stage is Nexus, a discrete differential current-feedback design. The output stage, called Continuity, is a constant-transconductance all-BJT stage with 24 Toshiba output devices rated at 150 W each. Schiit states that Continuity compensates for transconductance droop when the amplifier moves out of class A operation, so it can run with less bias than a class A design. There are no coupling capacitors or DC servos in the circuit.
Inside, a 600 VA transformer is followed by a choke-input filter on the main rails. That choke weighs 5.4 kg and is the same size as the power transformer, and filter capacitance totals 160,000 µF. Seven internal supply rails, including high-voltage boost rails, use discrete CFP regulators. A microprocessor monitors critical operating points such as DC offset and triggers a relay shut-down on overcurrent, thermal and other faults. Maximum consumption is 750 W, and standby draw is about 5 - 6 W.
Pairing
A preamplifier with balanced XLR or single-ended RCA outputs is required, and the input in use is selected by a rear-panel switch. The optional Forkbeard module adds instantaneous power output display, remote standby and alerts for over-temperature and over-current.
Alternatives
Schiit Audio has no other dedicated monoblock power amplifier in its range.