Hifiverse

Power amplifiers mono — Limestone PP1

Description, images, technical data and specifications

Limestone PP1
Image source - (c) Limestone

The PP1 is a class AB mono tube power amplifier from Limestone, the Croatian amplifier brand of WiM-Systems d.o.o. in Trnovec. Limestone combines retro styling taken from classic tube amplifiers with modern control electronics, and the brand name refers to the founder's father, a craftsman who made limestone by traditional methods. Every PP1 is hand-built, and its finish is made to order from a range of materials and colours. Prices start at EUR 10,000 excluding VAT.

Key specs that matter

Its output stage is push-pull with KT88 tubes. Power output is 45 W per channel. Frequency response is 30 Hz - 30 kHz (-3 dB), and THD is below 1% at 1 kHz. Signal-to-noise ratio is approximately 85 dB, with noise around 1 mV. Input sensitivity is 0.7 V RMS for the full 45 W. Output taps are 4 ohms and 8 ohms, on WBT gold-plated connectors. Dimensions are 250 x 250 x 550 mm (W x H x D), and weight is 18 kg.

Engineering and use context

Limestone builds the chassis from 1.5 mm stainless steel, and Kerrock decorative trims are applied to the exterior. Power-up and power-down are microprocessor-controlled, with delayed high-voltage activation at switch-on and capacitor discharge at switch-off. Protection circuitry guards the tubes against bias voltage failure.

A bias control system sets the operating point of the KT88 output tubes. Bias is adjusted with a high-precision Simpson analogue meter, and according to Limestone it can be set to match a variety of tubes. On the front panel are a VU meter, the power switch and a motorised ALPS potentiometer for volume. This potentiometer is adjusted automatically during startup and shutdown.

Pairing

A loudspeaker with 4 or 8 ohms nominal impedance connects to the matching output tap. A source or preamplifier delivering 0.7 V RMS is required for full output. The motorised ALPS volume control allows connection to a source with a fixed line-level output. A stereo system requires two units.

Alternatives

Limestone lists the PP1 as its only amplifier, so the brand has no other mono power amplifier.

Specifications

  • Model name

    PP1

  • Input sensitivity (mV)

    N/A

  • Input impedance (balanced) (Ω)

    N/A

  • Input impedance (single-ended) (Ω)

    N/A

  • Output impedance (balanced) (Ω)

    N/A

  • Output impedance (single-ended) (Ω)

    N/A

  • Max current (A)

    N/A

  • Output power (8Ω) (W)

    N/A

  • Output power (4Ω) (W)

    45

  • Gain (dBu)

    N/A

  • Frequency response low +/- 3dB (Hz)

    30

  • Frequency response high +/- 3dB (Hz)

    30000

  • Signal to Noise Ratio (dB)

    N/A

  • Total Harmonic Distortion + Noise (0% global feedback) (%)

    1.0

  • Total Harmonic Distortion + Noise (100% global feedback) (%)

    N/A

  • Max power consumption (W)

    N/A

  • Damping factor

    N/A

  • Dimensions (mm)

    250 x 250 x 550

  • Weight (kg)

    18

  • Official link

Related content