The PA1 is a mono power amplifier from Grimm Audio of Veldhoven in the Netherlands, a company founded in 2004. It made its public premiere at High End Vienna 2026 and is the first dedicated power amplifier from the brand, following the PW1 phono stage. Industrial designer Michiel Uylings drew the cabinet. The output stage is an evolution of a 1985 design by the late Henk ten Pierick, and Grimm calls the model the Pierick Amp.
Key specs that matter
Output power is more than 100 W into 8 ohms and more than 200 W into 4 ohms. Gain is 26 dB or 18 dB (selectable). THD is below 0.0001% (1 W, 8 ohms), and THD+N is -96 dB (1 W, 8 ohms). Signal-to-noise ratio is 96 dB (1 W, 8 ohms). Output impedance is below 10 milliohms, damping factor is above 800 re 8 ohms, and frequency response is 0.1 Hz - 300 kHz. Input impedance is 33 kohms on XLR and 16 kohms on RCA, and loudspeakers connect to 4 mm binding posts. Power consumption is 65-600 W in operation and below 5 W in low power mode. Each unit measures 250 x 250 x 240 mm (W x D x H) and weighs 15 kg.
Engineering and use context
Grimm describes the PA1 as a class AB design with a fully symmetrical output stage of 96 small, fast power transistors for very high bandwidth. All of them sit on an aluminium printed circuit board with tight thermal coupling, together with the output driver circuit that sets the quiescent current. According to Grimm, this keeps the output stage impedance constant over the full crossover region, even when large low-frequency currents flow to the loudspeaker.
Feedforward corrections in the power stage and the other signal stages keep phase modulation low. A second-order global feedback loop is also used. The input signal path has no series coupling capacitors and runs on multilayer PCBs. Its protection circuitry works without series relay contacts in the output. Above a heatsink temperature of 70 °C or a DC output voltage of 2.5 V, the amplifier shuts down. Its linear power supply uses an Amplimo toroidal transformer, 90,000 µF of supply decoupling capacitance and an automatic line voltage switch, and the driver and feedback circuitry have their own locally stabilised supply. In auto mode the amplifier switches on with an input signal and returns to standby after about 40 minutes of silence. Grimm gives a 5-year limited warranty.
Pairing
Two units are required for stereo. The 26 dB setting is intended for most preamplifiers, and the 18 dB setting for preamplifiers with very high output voltage or for high-sensitivity horn loudspeakers. Both output terminals carry signal, so bridged operation of two PA1 units is not allowed.
Alternatives
Grimm Audio has no other mono power amplifier in its range.