The Evolution Monoblock is a class A tube power amplifier from Doshi Audio, handcrafted in the USA, with one chassis per channel. It builds on the Doshi V3 Monoblock, and Doshi names the power supply as the area of the largest changes - a larger transformer, passive power factor correction, Schottky rectifiers and larger power supply capacitors. Input and driver circuitry were redesigned for lower feedback and higher bandwidth.
Key specs that matter
Each monoblock has one 12SJ7 input tube, two 12SN7 driver tubes and four KT150 output tubes. Output is at least 160 W RMS, and other output impedances are available on special order. Frequency response is 10 Hz - 75 kHz (±1 dB, 1 W). Hum and noise are at least 80 dB below 0 dBW (1 W), A-weighted. Input impedance is 40 kohms single-ended and 20 kohms balanced, and sensitivity is 1.4 V for full output. Output impedance is 0.5 ohms, with a damping factor of at least 10. Idle power consumption is 200 W.
Engineering and use context
Doshi describes a three-stage design with a classical pentode input stage, a dual triode driver and a pentode output stage on the KT150, with approximately 17 dB of feedback. Power comes from a custom power transformer with regulated supplies. Its output transformer has 14 interleaved sections and a 102 mm core rated for 400 W at 20 Hz. Toroid Corp in the USA makes the audio transformers, and custom ClarityCap CMR coupling capacitors come from ICW in the UK.
Carried over from the V3 is the 14-gauge stainless steel chassis. A constrained-layer damped aluminium top plate provides vibration isolation, isolation grommets are used on all circuit boards and outrigger legs add a further layer. Tube sockets are Teflon with gold-plated copper pins.
A microprocessor controller provides control and protection. It shuts the amplifier down on over-current in any tube or a bias supply fault, and an LED marks a failed output tube. Bias is set from front-panel push buttons, with a three-digit display reading for each KT150 and one potentiometer per tube. Doshi specifies 190, within a 170 - 220 window, with all four tubes within ±5 units. KT88 and KT120 also work in the output stage. Finish is natural anodised aluminium.
Pairing
The RCA input is a direct single-ended input, and the XLR input is a unity gain differential instrumentation amplifier. A ground lift switch is provided for direct mode, and a rear Speaker Mute Override mutes the output during speaker cable changes. A 12 V trigger input with loop-through output links it to a Doshi preamplifier or a home theatre processor.
Alternatives
The V3 Monoblock is the earlier Doshi Audio tube monoblock on which the Evolution is based.