The Ankoru/II is a tube mono power amplifier from Audio Note (UK), sold as a pair with one chassis per channel. Each chassis is a pure class A parallel single-ended design with a pair of 211 triodes. Audio Note says the Ankoru/II uses a circuit design and topology similar to its Gaku-On amplifiers, but where the Gaku-On uses silver wherever possible, including all transformer windings, the Ankoru/II uses copper. Its creator is Andy Grove. The top plate is offered in anodised aluminium or black anodised aluminium.
Key specs that matter
Maximum output is approximately 45 W per channel into 4 or 8 ohm loads. Input impedance is 2.4 kohms (XLR, balanced line level), and channel balance is ±0.3 dB. Tube complement per chassis is 2 x 211, 2 x 5R4WGB and 1 x 6V6GT. Each amplifier measures 305 x 305 x 640 mm (H x W x D) and weighs 37.5 kg. Mains input is AC 100-120 V or 220-240 V, 50/60 Hz, with a 3.15 A anti-surge fuse for 110/120 V and a 1.2 A anti-surge fuse for 200/240 V.
Engineering and use context
Audio Note states that the Ankoru/II was engineered for sonic performance rather than technical specification and meets all of its Level 3 criteria - pure class A operation, zero negative feedback, a single-ended output stage, tube rectification, directly heated triode operation, and materials and component quality. The 6V6GT is the small-signal tube and sits in the front socket.
Both amplifiers are shipped without the tubes installed. Every 211 has a small locating pin on the side of its base, which is lined up with the locating hole in the top-plate aperture before the tube is twisted clockwise until it locks. On the 5R4WGB a rib on the central pin allows insertion only one way. Audio Note advises professional installation if the owner is unsure. Each chassis has one XLR balanced input at the front of its left-hand side, a ground post, two colour-coded speaker binding posts and its own IEC 320 mains inlet, with separate fuse holders on the rear panel. A rocker switch sits at the top left of the back panel above the mains inlet. The amplifiers are switched on last and off first. Audio Note rates the tubes for approximately 4000 hours of operation and specifies replacement with matched pairs.
Pairing
A preamplifier with XLR balanced outputs is required. A separate ground post is provided for sources with their own ground terminal.
Alternatives
The Gaku-On is the Audio Note mono power amplifier with a similar circuit, a directly heated VT25 driver and a pair of paralleled VT4-C/211 power tubes.