The 858 is a dual-mono stereo power amplifier from Lindemann, the German electronics maker. It contains two fully separate mono amplifiers in one chassis and is not a monoblock. Lindemann built it in Germany in limited numbers as part of the 800-Series, its manual is dated 2012, and by 2015 the model had moved to the archive of discontinued products. Other members of the series were the 850, 852 and 855 dual-mono power amplifiers, the 830S and 832 control amplifiers, the 885 integrated amplifier and the 825 disc player.
Key specs that matter
Output is 240 W per channel into 8 ohms and 450 W into 4 ohms at less than 0.1% THD. Frequency response is 1 Hz - 200 kHz (-3 dB), and voltage gain is 26 dB. Its only inputs are one pair of balanced XLR connectors, with an input sensitivity of 1.87 V for full output into 4 ohms. Output impedance is below 20 mOhm at 100 Hz. Two pairs of WBT speaker terminals take spades or 4 mm plugs. Power consumption is 1500 W maximum, 80 W at idle and 0.5 W in standby. Dimensions including feet are 440 x 165 x 345 mm, and weight is 27.1 kg.
Engineering and use context
Both amplifiers share only the mains socket, and each has its own 800 W transformer. A fully balanced signal path gives high common-mode rejection. Lindemann describes the circuit as a current-mode amplifier with current feedback, using a single-ended push-pull principle taken from tube design. Parts count is low, signal paths are short, and the circuit uses thin-film resistors, film capacitors and highly linear Japanese transistors.
Each channel has 16 power transistors of the thermal-track type, arranged as low-inductance H-bridges. An on-chip temperature diode in every transistor sets the quiescent current without delay. With a bridged output, both speaker terminals are live, and the black terminal must never be connected to earth. Cooling is by a speed-controlled fan. Protection covers DC, overcurrent, overtemperature and mains failure, with an inrush current limiter and status LEDs on the front.
On the rear, an RJ-45 SYSCOM connection links the 858 to the Lindemann 830 and 832 preamplifiers for automatic switch-on, and a trigger input accepts 5 to 12 V DC.
Pairing
A preamplifier with a balanced XLR output is required. Lindemann advises against preamplifiers with weak output stages, tube preamplifiers in particular, because of the low input impedance. The matching preamplifiers are the Lindemann 830S and 832.
Alternatives
The 855 is another dual-mono stereo power amplifier in Lindemann's 800-Series.