The SLI-80HS is a push-pull tube integrated amplifier from Cary Audio of Raleigh, North Carolina. It is the Heritage Series version of the long-running SLI-80, made in collaboration with Klipsch, whose wood side panels match the Klipsch Heritage Series loudspeakers. The SLI-80HS was announced and began shipping in May 2019 at a list price of USD 4,495.
Key specs that matter
Circuit type is push-pull ultra-linear in class AB1, with an output of 40 W per channel in triode mode and 80 W per channel in ultra-linear mode. Its tube complement is two 6922 input buffers, two 6SN7 pre-drivers and phase inverters and four KT88 output tubes. Input sensitivity is 0.45 V for full output, input impedance is 100 kohms and maximum gain is 34 dB. Frequency response is 19 Hz - 23 kHz (±0.5 dB at full power), and noise and hum are 82 dB below rated output. There are three pairs of RCA inputs, one pair of speaker posts with a 4/8 ohm switch, an RCA subwoofer output and a 6.35 mm headphone jack. It measures 432 x 178 x 406 mm (W x H x D) and weighs 19.1 kg.
Engineering and use context
According to Cary, the output transformers were designed specifically for this amplifier. Negative feedback is taken from the 8 ohm tap of the output transformer secondary, and only 4 dB of it is used. Output tubes run with a negative fixed bias supply, factory preset to 75-85 mA and adjustable through a bias jack when replacement tubes are installed. The output sockets also take 6550, EL34, 6CA7, KT77, KT90 or KT120 tubes.
At the input, a series regulated push-pull (SRPP) class A triode stage is direct-coupled to the phase inverter, a self-balancing split-load circuit on the 6SN7 dual triode. From the volume control the signal goes directly to the first grid of the 6922, with no coupling capacitors in the input path. The subwoofer output is taken from the wiper of the volume control. Power comes from an EI laminate transformer with a 200% duty cycle. Cary states that the amplifier overloads symmetrically at any frequency in the audio band and that the high-voltage rail varies by no more than one volt.
Volume and mute are remote-controlled over IR, and a toggle switch routes the signal to the headphone jack and mutes the speakers. Its chassis has a matte black powder coat and a silver or black aluminium faceplate. Wood side panels in Black Ash, Cherry or Walnut and a removable cage cover are extra-cost accessories.
Pairing
The output taps are switched to match 4 ohm or 8 ohm loudspeakers. Line-level sources connect to the three RCA input pairs. A powered subwoofer connects to the RCA subwoofer output.
Alternatives
The Cary Audio SLI-100 is the higher-powered push-pull tube integrated amplifier with KT150 output tubes and 100 W per channel.