The KWH 225i is a hybrid integrated amplifier from ModWright Instruments, hand-crafted in Amboy, Washington. ModWright combined the solid-state output stage of its Reference KWA 150SE power amplifier with the controls and integration of the KWI 200 solid-state integrated amplifier, added a tube preamp stage and increased the power to 225 W. It is part of the company's current range.
Key specs that matter
Output is 225 W into 8 ohms and 400 W into 4 ohms at 0.04% THD. It operates in class AB, with the first 25 W in class A, and uses zero global negative feedback. Tube complement is two 6922 driver tubes, with 6DJ8, ECC88 and 7308 as acceptable substitutes. Gain is 30 dB and frequency response is 20 Hz - 100 kHz. Input impedance is 20 kOhm, input sensitivity 2 V rms and maximum input level 6 V rms (18 V peak-to-peak). Inputs are three RCA pairs, one XLR pair and one RCA home theatre bypass pair, and outputs are one RCA preamp output pair and two pairs of 5-way binding posts. Dimensions are 451 x 445 x 165 mm (W x D x H), and weight is 29 kg.
Engineering and use context
Transformer input coupling gives DC input protection, internal thermal sensors shut the amplifier down on thermal overload, and ModWright's proprietary TSP (Total Silent Protection) circuitry provides DC output protection from entirely outside the signal path.
Both tubes are self-biasing and need no adjustment. They sit in 9-pin sockets in a blue sub-enclosure at the rear centre of the top panel. After switch-on, output stays muted for approximately 45 seconds while the amplifier warms up and stabilises.
Pressing the HT/BP button routes the bypass input straight to the power amplifier section, with no attenuation or volume control, and ModWright recommends connecting only a separate preamp or a home theatre processor to it. The selected source is always present at the RCA preamp outputs. Volume runs from 01 to 99 on a digital display, and the remote covers power, volume, mute, input select and display dimming. An optional solid-state phono stage is user-installable and adds one RCA input with 50 dB of gain for MM and high-output MC cartridges. Its loading is set by internal DIP switches to 50, 100, 500 or 1000 ohms, 47 kOhm (stock setting) or 100 pF for MM.
Pairing
Loudspeakers of 8 or 4 ohms nominal impedance are within its ratings. The HT/BP input accepts a surround processor, and the RCA preamp outputs can drive a second amplifier. A low-output MC cartridge requires an external phono stage such as ModWright's PH 150.
Alternatives
ModWright has no other integrated amplifier in its current range.