The 9000A is an integrated amplifier from Audiolab with a built-in DAC, an MM phono stage, a headphone amplifier and Bluetooth in one case. It is the first component of the brand's 9000 Series, and Audiolab calls it the most advanced integrated amplifier it has made so far. Lead designer Jan Ertner developed it as the next step after the 6000 and 8000 Series. Black and Silver finishes are offered.
Key specs that matter
Power output is 2 x 100 W into 8 ohms and 2 x 160 W into 4 ohms (THD below 1%), and maximum output current is 15 A. Power amplifier THD is below 0.002% (1 kHz, 50 W, 8 ohms), and preamplifier THD is below 0.0004% (1 kHz, 2 V). Input sensitivity is 1 Vrms for line, 2 Vrms for XLR and 4.4 mV for phono MM, with input impedance of 10 kohms (line) and 47 kohms // 100 pF (phono MM). Signal-to-noise ratio is above 110 dB for line and XLR and above 80 dB for phono (A-weighted). Analogue inputs are three line, one balanced XLR, one phono MM and one power amplifier input. Digital inputs are two coaxial, two optical and one PC USB, plus Bluetooth 5.1 with aptX, aptX HD, AAC and LDAC. Dimensions are 444 x 89 x 342 mm (W x H x D), and net weight is 9.4 kg.
Engineering and use context
Its discrete Class AB power amplifier stage uses CFB (Complementary Feedback) topology, and idle current is held steady against output transistor temperature. A custom-specified 320 VA toroidal transformer is followed by 4 x 15,000 µF of reservoir capacitance. Conversion is by the ESS ES9038PRO 32-bit DAC chip with HyperStream II architecture and Time Domain Jitter Eliminator. Over USB it accepts PCM up to 768 kHz and DSD512, while the optical and coaxial inputs accept up to 192 kHz. For vinyl, Audiolab uses a JFET-based MM circuit with precise RIAA equalisation. A current-feedback headphone amplifier with wide bandwidth and high slew rate drives loads of 20 - 600 ohms.
Three operating modes are available. Integrated mode combines the pre and power amplifier stages, Pre-Power mode disconnects them so that an external processor can return to the power amp input, and Pre Only mode leaves a preamplifier. A 4.3-inch colour IPS LCD screen shows status, and firmware can be updated over USB.
Pairing
The phono input accepts MM cartridges. In Pre-Power mode the power amplifier input allows connection of a home-theatre processor. Matching components in the series are the 9000CDT CD transport and the 9000N streamer.
Alternatives
The Audiolab 7000A is the integrated amplifier of the lower 7000 Series.