Hifiverse

Phonovorstufen - Einstein Audio Components THE PHONOSTAGE

Beschreibung, Bilder, technische Daten und Spezifikationen

Einstein Audio Components THE PHONOSTAGE
Bildquelle - (c) Einstein Audio Components

THE PHONOSTAGE is a moving-coil phono preamplifier from Einstein Audio Components of Bochum, Germany. Its input stage is a discrete design with 10 single transistors, and op amps form the two following amplifier stages. Einstein's May 2023 price list describes it as a double-mono phono preamplifier at EUR 6,000.

Key specs that matter

Gain is 68 dB (2500 times) or 74 dB (5000 times), adjustable by jumpers. Signal-to-noise ratio is above 80 dB (1 mV, 1 kHz). Distortion is below 0.05% at 1 mV and 1 kHz, and channel balance is within ±0.5 dB, both without any feedback. Headroom is 10 dB, with a maximum input voltage of 3 mV at 1 kHz. RIAA equalisation is passive for high frequencies and active for lower frequencies. Output impedance is 100 ohms and maximum output voltage is 8 V RMS. Input loading is adjustable to any value up to 2 kohms with resistor loading plugs. The unit measures 215 x 360 x 150 mm (H x D x W) and weighs 6 kg.

Engineering and use context

As in other Einstein designs, THE PHONOSTAGE is built as a double-mono design for channel separation. Einstein uses its floating ground principle to avoid hum loops, and attributes the low noise of the unit to the shielding and the circuit design. According to Einstein, the power supply has large headroom and provides more than the phono stage requires.

Neither adjustment uses DIP switches in the signal path. Cartridge loading is set with custom-made RCA plugs that carry the load resistor and plug into the rear panel. A simple jumper selects the gain, and Einstein specifies the two settings for low-output and higher-output moving-coil cartridges.

Pairing

A moving-coil cartridge is required. The phono stage output requires a line-level input on the preamplifier or integrated amplifier. Matching Einstein products are THE PICK UP cartridge, THE TONEARM and THE RECORD PLAYER.

Alternatives

The Einstein THE PHONOAMP is a fully discrete moving-coil phono stage with 48 single transistors, passive RIAA, fixed 68 dB gain and an external dual-mono power supply.

Spezifikationen

  • Modellbezeichnung

    THE PHONOSTAGE

  • Eingänge (symmetrisch)

    N/A

  • Eingänge (unsymmetrisch)

    N/A

  • MC-Eingangsimpedanz (stromgekoppelt) (Ω)

    N/A

  • MM/MC-Eingangsimpedanz (spannungsgekoppelt) (Ω)

    N/A

  • Ausgangsimpedanz (Ω)

    100

  • Verstärkung (dB)

    N/A

  • Genauigkeit der Wiedergabe-Entzerrungskurven (dB)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Klirrfaktor + Rauschen (%)

    < 0.05

  • Abmessungen (mm)

    215 x 360 x 150

  • Gewicht (kg)

    6

  • Offizieller Link