THE PHONOAMP is a moving-coil phono preamplifier from Einstein Audio Components of Bochum, Germany, with a fully discrete single-transistor circuit and an external power supply. Einstein developed it in 2016. It is offered as a single version for one tonearm and as a double version for two tonearms, the latter with four phono stage elements (2 x 2) and two identical power supply boards. Einstein's May 2023 price list gives EUR 22,000 for the single version and EUR 30,000 for the double.
Key specs that matter
Gain is fixed at 68 dB (2500 times). Signal-to-noise ratio is above 82 dB (1 mV, 1 kHz). Distortion is below 0.04% at 1 mV and 1 kHz, and channel balance is within ±0.3 dB, both without any feedback. Headroom is 12 dB, with a maximum input voltage of 3.5 mV at 1 kHz. RIAA equalisation is passive. Output impedance is 60 ohms and maximum output voltage is 10 V RMS. Cartridge loading is adjustable to any value up to 2 kohms with resistor loading plugs. Phono unit and power supply each measure 215 x 360 x 150 mm (H x D x W), and they weigh 6 kg and 5.5 kg.
Engineering and use context
Einstein uses 48 single transistors in three amplifier stages. Each of the two dual-mono phono boards carries 24 closely selected transistors with thermal coupling. The signal enters a balanced high-current input stage with 10 FET transistors per channel and then passes through the passive RIAA equalisation. A discrete high-current output stage with low output impedance follows. For reasons of sound quality, feedback in the amplifier stages has been avoided, according to Einstein. Power supply decoupling is 14,000 µF on each preamplifier module.
Both boards sit separately in two floating-mounted, electrically decoupled steel tubes, and together with the aluminium housing these form a Faraday cage within a Faraday cage. Galvanic separation of the two channels and separate supplies prevent ground loops and crosstalk, with the ground connection established only at the connected amplifier. Its dual-mono power supply sits in a separate enclosure, with an input filter against mains interference, DC filtering with 10 x 2200 µF capacitors and electronic stabilisation with ample voltage reserves.
Pairing
A moving-coil cartridge is required, and there is no MM/MC switch and no gain switch. Sockets for the loading plugs sit parallel to the input sockets on the rear panel. Matching Einstein products are THE PICK UP cartridge, THE TONEARM and THE RECORD PLAYER.
Alternatives
The Einstein THE PHONOSTAGE is a moving-coil phono stage with a discrete input stage, op amps in the two following stages and gain of 68 or 74 dB set by jumpers.