The DP-450 is an MDS compact disc player from Accuphase of Japan and the successor to the DP-430. It was introduced in 2021 at a European price of EUR 5,600. The player reads CD only, without SA-CD support, and its converter section also accepts external sources through USB, optical and coaxial digital inputs. It uses technologies developed for the DP-570 SA-CD/CD player.
Key specs that matter
D/A conversion is 4MDS+ with one ESS ES9026PRO DAC chip. Frequency response is 0.7 Hz - 50 kHz (+0, -3 dB). THD+N is 0.0008% (20 Hz - 20 kHz), signal-to-noise ratio is 119 dB, dynamic range is 116 dB and channel separation is 113 dB. Balanced XLR and line RCA outputs each give 2.5 V at 50 ohms. The USB 2.0 Type B input accepts PCM up to 384 kHz/32-bit and DSD 2.8, 5.6 and 11.2 MHz (11.2 MHz via ASIO only). Coaxial input accepts PCM up to 192 kHz/24-bit, optical up to 96 kHz/24-bit. Optical and coaxial transport outputs are provided. Power consumption is 11 W, dimensions are 465 x 151 x 393 mm (W x H x D) and net weight is 13.7 kg.
Engineering and use context
ES9026PRO has eight DACs inside, and the DP-450 connects four of them in parallel per channel in the MDS+ (Multiple Delta Sigma) circuit, with current summing before I-V conversion. Accuphase states that this almost doubles (the square root of four) performance for distortion, noise and linearity, independently of signal frequency and level. A fully balanced structure is used. In the Direct Balanced Filter the line and balanced outputs each have an independent low-pass filter. Its power transformer has separate analog and digital windings, and the low-noise power supply circuits use amplifier technology.
The CD drive sits in a recessed slot of the bottom plate, as low as possible. Elastic dampers connect the traverse and disc loading mechanisms and protect the lens actuator, and the chucking magnet is an 8-pole neodymium bonded magnet. A three-layer large bridge with open-cell foam surrounds the traverse mechanism. Accuphase reduced the chassis structure under the drive from seven pieces in the DP-430 to two. Machined from an aluminium block with a hard anodized finish, the disc tray runs on bearing shafts. The 1.6 mm steel chassis stands on high-carbon cast iron insulators.
A display shows the sampling frequency and quantization bits. Programmable playlists, a balanced output phase selector, a digital output level control in 1 dB steps and the RC-140 remote commander are included.
Pairing
A preamplifier or integrated amplifier with balanced XLR or RCA line inputs is required. An Accuphase voicing equalizer connects between the transport outputs and the digital inputs.
Alternatives
The Accuphase DP-570 is an SA-CD/CD player with an ES9028PRO-based 4MDS+ converter and HS-LINK.