Hifiverse

Subwoofer - JBL STAGE 200P

Beschreibung, Bilder, technische Daten und Spezifikationen

JBL STAGE 200P
Bildquelle - (c) JBL

The Stage 200P is the 250 mm powered subwoofer of the JBL Stage series, designed and engineered at the company's Acoustic Engineering Center of Excellence in Northridge, California. JBL describes it as matched with the entire Stage series. Two finishes are offered, Espresso or Latte woodgrain, each with a solid colour front baffle and a matching grille.

Key specs that matter

Amplifier power is 150 W RMS (300 W dynamic). Driver - 1 x 250 mm front-firing, high-excursion polycellulose ribbed cone woofer. Frequency response is 28 Hz - 150 Hz (±6 dB). Low-pass crossover is 50 Hz - 150 Hz (variable), 24 dB/octave. Input - one line-level LFE input. Power requirement is 120 V, 60 Hz (US) or 220 - 230 V, 50/60 Hz (EU), with under 0.5 W in standby and 205 W max. Dimensions are 361 x 350 x 385 mm (H x W x D), weight 14.4 kg, or 18.3 kg shipping.

Engineering and use context

According to JBL, the cone is pure pulp with a proprietary mix of other materials added to improve its rigidity. Bass-reflex loading comes from dual rear-firing flared tuned ports, and the flared design reduces the velocity of the air leaving the cabinet. Like the rest of the Stage 2 line, the 200P has a magnetically attached grille, trim rings and a floating front baffle design.

Rear-mounted controls are Auto Power, Crossover, Level and Phase. In Auto mode the subwoofer turns on when an audio signal is detected and returns to standby after about 15 minutes without one. Its LED glows blue when on and red in standby. A main voltage selector switch on the rear panel, 220 - 240 V or 100 - 120 V, must be set before the power cord is plugged in. Four floor spikes come in the box, screw into each foot on the plinth and are adjustable from the top. Also supplied are the power cord and the grille.

When the LFE output of a receiver is used, JBL specifies turning the crossover fully clockwise so that the receiver's crossover is in use. With preamp outputs instead, an RCA Y-adapter cable connects to the single input.

Pairing

The matching loudspeakers are the Stage series models. An AV receiver or processor with a subwoofer LFE output or preamp outputs is required. The LFE cable is not supplied.

Alternatives

The JBL Stage 220P is the larger subwoofer of the series, with a 300 mm woofer, 250 W RMS (500 W dynamic) and a weight of 18.7 kg.

Spezifikationen

  • Modellbezeichnung

    STAGE 200P

  • Untere Grenzfrequenz +/- 3dB (Hz)

    28

  • Obere Grenzfrequenz +/- 3dB (Hz)

    150

  • Empfindlichkeit (dB at 1 W/1m)

    N/A

  • Impedanz (Ohms)

    N/A

  • Verfügt über interne Verstärkung

    Ja

  • Endverstärker (W)

    150

  • Größe (sm)

    36.1 x 35.0 x 38.5

  • Gewicht (kg)

    14.4

  • Offizieller Link

Weitere Komponenten