The X2t is a slim floorstanding loudspeaker in the X Series of Raidho Acoustics, Denmark, a range whose X stands for extreme performance for the price. It replaces the X2 and uses the improvements first made for the X1t monitor, shown at High End 2022. Its ribbon tweeter is almost the same as the one in the Raidho TD6, a EUR 210,000 model. EU pricing is EUR 14,000 per pair, with an additional charge for colours other than the standard finishes.
Key specs that matter
Design is 2.5-way with an internal vented enclosure and a rear port, which Raidho calls Adaptive Rear Port. The driver complement is one Raidho ribbon tweeter and two 5.25-inch Raidho Ceramix drivers with tantalum coating. Crossover points are 130 Hz and 3.4 kHz, second order. Frequency response is 45 Hz - 50 kHz (±3 dB), sensitivity is 87 dB (2.83 V/1 m) and impedance is 6 ohms. Amplification should be at least 50 W, and recommended room size is 15 - 50 m2. Dimensions are 300 x 1065 x 445 mm (W x H x D) including feet, and each speaker weighs 23 kg.
Engineering and use context
Both Ceramix drivers produce bass, while only the upper one covers the midrange. Each cone starts as a lightweight aluminium cone whose outer surfaces are converted into aluminium-oxide ceramic, a naturally bonded sandwich. On the X2t the membrane also carries a coating of tantalum, a refractory metal with a melting point of 2,996 degrees C. According to Raidho, this coating makes the membrane stiffer and harder without adding weight and raises the breakup modes to 15 kHz. Neodymium magnets drive a titanium voice coil in an open motor structure, where airflow cools the coil.
Raidho designs and builds its planar magnetic tweeter by hand in Denmark. Its voice coil is formed by tracks in an 11-micron foil that weighs 20 mg, around 50 times less mass than a conventional dome, and the first breakup is at 82 kHz.
Compared with the X2, the crossover uses better components, is hard-wired point-to-point by hand and includes Nordost cable. Internal wiring is Nordost with Norse technology, as used in the Nordost Valhalla models. Instead of spikes, decoupling is integrated into the feet, where the speaker rests on metal balls. The cabinet itself is 143 mm wide and 410 mm deep. Finishes are black or white high gloss, with custom colours on request.
Pairing
Solid-state integrated and power amplifiers above Raidho's minimum power can drive the 6 ohm load. Single-wire terminals take one pair of speaker cables per side.
Alternatives
The Raidho X2.8 is a larger three-way floorstanding loudspeaker in the X Series with dual 8-inch bass drivers.