Hifiverse

Standlautsprecher - Lansche Audio No.9.2

Beschreibung, Bilder, technische Daten und Spezifikationen

Lansche Audio No.9.2
Bildquelle - (c) Lansche Audio

The No.9.2 is a passive floorstanding loudspeaker in the P-Series of the German maker Lansche Audio, listed above the No.8.3 in the range. Like every Lansche speaker it is built with the company's own CORONA plasma tweeter. Each cabinet is 219 cm high, 45 cm wide and 65 cm deep. Under 2022 pricing a pair cost EUR 184,900. Standard finishes are white and black piano lacquer and natural veneer, and a Macassar veneer version has also been shown.

Key specs that matter

Design is a 3.5-way bass reflex system. Seven drive units are used - one 8 mm CORONA plasma tweeter, two 165 mm papyrus coated midrange drivers, two 203 mm papyrus coated midrange drivers and two 406 mm paper coated woofers. Crossover frequencies are 80 Hz, 200 Hz and 2.5 kHz. Frequency range is 18 Hz - 150 kHz (±3 dB). Sensitivity is 93 dB (1 W/1 m), and nominal impedance is 4 ohms (min. 3.4 ohms). Weight is 350 kg per speaker.

Engineering and use context

Below the tweeter, six cone drivers are crossed over at three points, with the paper coated woofers in the lowest section and the four papyrus coated units above them.

At the top, the CORONA tweeter has no voice coil, no membrane, no mass-spring system and no suspension. An 8 mm long arc is set up between a small curved annulus in the middle of the combustion chamber and a high-voltage outer electrode. This arc forms an ionised gas cloud, or ion field, with five times less area and 100,000 times less weight than a fixed membrane. Its points are accelerated in unison by changes in electric field strength as the music signal modulates the field, and the emission is virtually a point source. The tweeter module covers 1.5 kHz - 150 kHz.

Lansche notes that it took considerable engineering work to align the mass-loaded midrange and bass drivers with the nearly massless tweeter without a time delay.

Pairing

An amplifier stable into 4 ohms is required. The speaker is fully passive and needs no mains connection.

Alternatives

The No.8.3 is the 3-way Lansche model below it, with six 229 mm aluminium coated woofers, an 8 ohm nominal impedance and a weight of 220 kg.

Spezifikationen

  • Modellbezeichnung

    No.9.2

  • Untere Grenzfrequenz +/- 3dB (Hz)

    18

  • Obere Grenzfrequenz +/- 3dB (Hz)

    150 000

  • Empfindlichkeit (dB at 1 W/1m)

    93

  • Impedanz (Ohms)

    4

  • Anforderungen an den Endverstärker (W)

    N/A

  • Verfügt über interne Verstärkung

    k. A.

  • Leistung der internen Verstärkung (W)

    N/A

  • Größe (sm)

    N/A

  • Gewicht (kg)

    350.0

  • Offizieller Link

Weitere Komponenten