Indiana Line, the Italian speaker maker, places the passive Diva 6 floorstanding speaker at the top of its current Diva series, which sits below the newer Lira range in the catalogue. Five drivers occupy the front baffle of the vented cabinet, and the speaker is sold in pairs at EUR 1,598.
Key specs that matter
Three woofers and a midrange share the same nominal 15 cm size, a figure that includes the mounting flange, so the radiating cones measure about 13 cm. Above them a 26 mm silk dome tweeter handles the top octaves. The crossover points sit at 300 Hz and 3,500 Hz. Indiana Line rates the frequency range at 35 Hz to 23,000 Hz and sensitivity at 93 dB at 1 W and 1 m, lists a 4 to 8 ohm load and recommends amplifiers of 30 to 160 W. Each cabinet stands 957 mm tall, 220 mm wide and 335 mm deep and weighs 18.5 kg.
Engineering and use context
All four cones are made of Curv, a thermoformed polypropylene composite, and are held by a rubber Dual-Wave surround with a double roll. Their die-cast aluminium baskets use spokes shaped to reduce reflections behind the diaphragm, and the midrange motor adds an AluRing aluminium shorting ring. The tweeter has a rubber front plate, a double magnet assembly and a rear decompression chamber. In the crossover, the tweeter section uses air-core coils and plastic film capacitors, while the midrange and bass sections combine air-gap coils with non-polarised electrolytic capacitors. The MDF enclosure is 25 to 30 mm thick, with the thickest panel at the front, where the baffle is angled slightly upward. Internal braces stiffen the walls and white polyester wadding partly fills the volume. Bass-reflex loading comes from a port near the bottom of the enclosure. Bi-wiring is not supported, as each cabinet carries just two binding posts. Buyers choose between black woodgrain and white oak cabinets, each with a matte lacquered front in black or white, and the grilles attach magnetically.
Pairing
With three woofers working in parallel, the load presented to the amplifier falls toward the lower end of the rated band, so the amplifier should be one that copes comfortably with a 4 ohm load. The high efficiency lets modest transistor amplifiers and well-specified tube designs drive the pair to useful levels in an average living room, and with just one set of terminals per cabinet the wiring stays simple.
Alternatives
The Indiana Line Tesi 6 is a lower-priced floorstanding speaker from the Tesi series at roughly half the cost of the Diva 6.