The YU4 is a powered two-way bookshelf speaker pair from the first-generation YU series of Kanto, designed in Canada and made in China. It sits between the YU2 and the YU6 and adds a phono preamp, optical inputs and Bluetooth to a compact cabinet. Its price was USD 419.99 per pair, in matte black, matte white, bamboo and walnut. This generation is now discontinued. As in the other YU models, the active left speaker holds the electronics and the passive right speaker connects to it with speaker wire.
Key specs that matter
Each speaker has a 25 mm silk dome tweeter and a 102 mm Kevlar mid/woofer driver, with a 2-way crossover at 2.0 kHz. Amplifier type is class D, rated at 140 W peak power (70 W total RMS) into a nominal impedance of 4 ohms. Frequency response is 60 Hz - 20 kHz. Input sensitivity is 560 mV and total harmonic distortion is below 0.25%. Inputs are 1 x RCA L/R with phono switch, 1 x 3.5 mm AUX, 2 x optical (Toslink) and Bluetooth 4.0 with Qualcomm aptX. Outputs are one subwoofer output and a 5 V 1.0 A USB charge port. Each speaker measures 140 x 220 x 190 mm (W x H x D), and net weight is 3.2 kg active and 2.5 kg passive.
Engineering and use context
A built-in phono preamp sits behind the RCA input, selected by a Phono/Line switch, with a turntable ground post beside it. A DAC for both optical inputs supports data streams up to 24-bit/96 kHz, and the source output has to be set to stereo, not surround, Dolby, DTS or 5.1. Its USB charge port stays active in playback and in standby. Knurled five-way binding posts link the active speaker to the passive one.
On the front, one knob sets the volume, cycles through RCA, AUX, OPT1, OPT2 and Bluetooth on a push and enters standby on a push and hold. A status LED shows playback in white, standby in yellow and Bluetooth in blue. After 15 minutes without a signal the amplifier goes into standby, and it wakes when the signal returns on the same input, except on Bluetooth. The remote carries direct input keys, Bluetooth reset, volume, bass and treble with reset keys, mute, balance and Bluetooth track controls. Mains input is AC 100 - 240 V at 50/60 Hz, standby consumption is under 0.5 W, and a 1/4-20 threaded hole is on the bottom. Included are the remote with AAA batteries, a 3.5 mm AUX cable, a power cord, speaker wire and eight rubber feet.
Pairing
A turntable without its own preamp uses the Phono setting, and one with a built-in preamp must use Line. The speaker terminals must not be connected to a stereo amplifier. Its mono subwoofer output matches the Kanto sub6 and sub8, and the matching stand is the Kanto SP26.
Alternatives
The Kanto YU6 is the larger pair of the same series, with 133 mm Kevlar woofers and 200 W peak power.