The Conquest is a pair of mono power amplifiers from Audio Note (UK). Each chassis is a pure Class A parallel single-ended tube amplifier with two 300B triodes per channel. Audio Note says the Conquest was engineered for sonic performance rather than technical specification. Six current versions exist - Conquest, Conquest Low Gain, Conquest Silver, Conquest Silver Low Gain, Conquest Silver Signature and Conquest Silver Signature Low Gain.
Key specs that matter
Maximum output is 18 W RMS per channel into 4 or 8 ohm loads. Input impedance is 100 kohm, and input sensitivity is 250 mV for full output, or 3.15 V on the Low Gain versions. Channel balance is ±0.3 dB. Each amplifier measures 195 x 205 x 506 mm (H x W x D) and weighs 20 kg. Mains input is AC 100-120 V or 220-240 V, 50/60 Hz, with a maximum power consumption of 200 W.
Engineering and use context
All Audio Note (UK) Level 3 criteria apply here - pure Class A operation, zero negative feedback, a single-ended output stage, tube rectification, directly heated triode operation, and materials and component quality. Every chassis carries one 5U4GB rectifier, two 300B output tubes and one 6SN7 input stage tube, and Audio Note lists a metal 6J5 for the Low Gain versions. Its rear panel has a single RCA input, an IEC 320 mains inlet and three colour-coded binding posts marked 0, 4 ohm and 8 ohm.
On the Silver version, the upgrades are AN-V internal cable, 1 W tantalum film resistors, Audio Note copper foil signal capacitors and IHiB double C-core output transformers. The Silver Signature moves to AN-Vx internal cable, 2 W tantalum film resistors and SHiB double C-core output transformers, again with copper foil signal capacitors. Fascias come in anodised aluminium or black acrylic, and top plates in anodised or black anodised aluminium.
According to the owner's information, a new pair needs about 100 hours of bedding in, and the tubes last approximately 6000 hours. Replacement tubes should be matched pairs.
Pairing
A preamplifier with an RCA output is required. The Low Gain versions require a line stage able to deliver 3.15 V. Loudspeakers of 4 or 8 ohms connect to the matching tap. The Conquest is the last component to be switched on and the first to be switched off.
Alternatives
The Audio Note (UK) Quest is a pure Class A single-ended mono power amplifier with a single 300B triode per channel and 8 W RMS per channel.