The TB200 is an integrated tube hybrid amplifier from Kora, designed and built in Toulouse in the Occitania region of France. It is the middle model of Kora's three class AB integrated amplifiers, above the TB140 and below the TB400, and has line inputs only. The TA240 power amplifier is its non-integrated version, with larger power transformers. Its French price is EUR 11,760.
Key specs that matter
Output power is 2 x 100 W into 8 ohms and 2 x 180 W into 4 ohms. There are four RCA line inputs with 15 kOhm input impedance and 1 V sensitivity, plus a pre-out with 2 kOhm output impedance. Bandwidth is 20 Hz - 20 kHz (±1 dB), and output impedance is below 0.08 ohm. Overall dimensions are 148 x 420 x 350 mm, the chassis alone is 130 x 420 x 320 mm, and weight is 19 kg. Maximum power consumption is 310 W at 2 x 100 W into 8 ohms and 610 VA at 2 x 180 W into 4 ohms, from 230 V mains (117 V on request).
Engineering and use context
All Kora amplifiers use the Square Tube operational amplifier, and in the TB200 it has four triodes per channel. According to Kora, the Square Tube provides all amplification and control of the audio signal. Twelve complementary highly linear ON Semi power transistors, rated 225 W and 15 A each, supply the current the loudspeakers need without interfering in amplification, an arrangement Kora calls impedance matching. Kora states there are no low- or high-frequency phase shifts and no current limitation, and that the amplifier is stable into complex loads.
Inside is a dual power supply with two 300 VA transformers, 2 x 60,000 µF of main filtering and internal rails of 2 x ±50 V DC. Auxiliary voltages come from five DC/DC converters and two linear regulators. High voltage is stabilised at +300 V and -200 V, and both input and output tube heaters run on regulated 12 V DC. Its main switch sits under the left front edge, beneath the engraved Kora logo, and Kora advises waiting a few minutes between power-up and start-up for the pre-charge circuit. Level runs from 00 to 80, set by the single front knob or the metal remote control, which also has a mute key. Balance covers ±10 steps and each input has its own gain offset. Input 4 can be set as a bypass input, turning the TB200 into a power amplifier, or as a pre-out after the volume control. The case is aluminium and steel in Mineral grey, with a five-year warranty.
Pairing
A turntable requires an external phono stage. In bypass mode a source or preamplifier with volume control is required. The pre-out allows an active subwoofer.
Alternatives
The Kora TB400 is the larger integrated amplifier above it, rated at 2 x 200 W into 8 ohms and sold for EUR 17,040 in France.