A GaN FET amplifier is a class D design whose output transistors are made of gallium nitride instead of silicon. These parts switch faster and with lower losses, so compact amplifiers can deliver high power with little heat and fit on a desk.
A class D stage turns the signal into a train of pulses and filters the result. Silicon MOSFETs need a safety gap, called dead time, between switching events, and that gap adds distortion. GaN transistors switch with sharper edges, have no body diode and no reverse recovery loss, which allows shorter dead time and higher switching frequencies. In practice this means smaller heatsinks, lighter cases and lower distortion figures.
SMSL VMV A1 Pro, a desktop amplifier built on Infineon GaN FETs, is the subject of the one launch report so far. The article lists its power ratings into 2 and 4 ohm, the bridged mono mode over XLR input, the pass-through mode and the volume control chip. Coming news on GaN amplifiers, power supplies and active speakers will collect on this page.
SMSL VMV A1 Pro - Infineon GaN FETs switching at up to 1 MHz, a Texas Instruments PGA2311 volume chip and a weight of 1.56 kg. SMSL PA200 and PA400 - the brand's GaN power amplifiers on the same output devices. JAVA Hi-Fi Single Shot and Double Shot - LDR (light dependent resistor) volume control ahead of GaN power stages. Orchard Audio Starkrimson - GaN output stages switching at 1.1 MHz.
Read Solid-State Amplifiers for wider context and Class AB Amplification for the linear alternative. Speaker and Amplifier Matching helps with loads, and GaN models can be browsed among Amplifiers in the catalog.