Class AB amplification is a push-pull output design in which each device conducts for slightly more than half the signal cycle. It is the most common way Hi-Fi amplifiers balance low distortion with practical efficiency in both transistor and tube designs.

John Makovsky

John Makovsky
In a push-pull stage, two devices handle opposite halves of the waveform. Pure Class B leaves both off near zero volts, which creates crossover distortion. Class AB adds a small bias current so that one device is already conducting before the other stops. Efficiency falls between Class A and Class B, so an amplifier runs cooler than a Class A design and needs smaller heatsinks and power supplies for the same output.
Here sits a comparison of high-end integrated amplifiers published in two parts, most of them built around Class AB output stages. Part one surveys thirteen integrated models in the USD 8000 to 22000 bracket, with rated specifications and circuit types. Part two turns to practical use, with loudspeaker pairing advice and a matrix of specifications for each amplifier.
Bias current - the idle current that sets how far a stage leans toward Class A. Crossover distortion - the error that Class AB biasing is meant to remove. High bias designs - some makers run the first watts in Class A before moving to AB. Push-pull pairs - transistors or tubes working in antiphase on each half of the signal. Quiescent current drift - why many designs track temperature to hold bias steady.
Compare with Class A Amplification and Solid-State Amplifiers. Balanced Amplifier Design and Speaker and Amplifier Matching help with system choices. Browse integrated and power amplifiers in the catalog's amplification pages.