Hifiverse

Tonarme - Reed REED 5T

Beschreibung, Bilder, technische Daten und Spezifikationen

Reed REED 5T
Bildquelle - (c) Reed

The Reed 5T is the statement tonearm of Reed, the Lithuanian maker based near Kaunas and owned by radio engineer Vidmantas Triukas, who presented his first Reed arm in 2008. It is the fifth model in the Reed range and is offered by Dohmann Audio alongside its Helix turntables. Like the Reed 5A, it is a tangentially tracking pivoted tonearm, but its angular position is set by a motor under laser control.

Key specs that matter

Maximum tracking error is ±5 minutes of angle (MOA). Mounting distance is 251 mm, for platters up to 330 mm in diameter and 28 - 48 mm high. VTA adjustment has a precision of ±0.2 mm, and azimuth adjustment is ±8°. Downforce range is 10 - 30 mN, for cartridge masses of 5.5 - 19.5 g (4.0 - 25.0 g extended). Effective mass depends on the armwand - 10 - 14 g in Wenge or Macassar Ebony, 12 - 18 g in Cocobolo and 8 - 14 g in Teak Light or Teak Dark. Supply voltage is 12 V DC. Finishes are Seashell White, Black and Gold Matte.

Engineering and use context

Its geometry is the Double Birch/Thales layout, which Reed describes through the Thales semicircle and the circle drawn through three non-collinear points. Angular rotation of the arm comes from a limited rotation sectional torque motor of Reed's own design, and a laser beam and a linear sensor array control its position. According to Reed, this pairing of laser, sensor array and motor was a world first in audio. The arm tube suspension is similar to the one in the Reed 2G, and the turning part sits on a low noise thrust-sleeve bearing. Its user-replaceable arm tube changes the effective mass, and the headshell is also replaceable.

Against pivoted tonearms, which Reed says usually reach a tracking error of up to 1.5 degrees, the 5T has a smaller moment of inertia and needs no anti-skating mechanism. Compared with other tangential designs, its moment of inertia is a few times smaller, no air compressor or similar auxiliary device is used, and effective mass is similar in the vertical and horizontal planes.

Pairing

A battery supply, the Reed Source 12V, is required. The armwand choice sets the effective mass for the cartridge compliance. Mounting requires a turntable that accepts the specified mounting distance and platter height.

Alternatives

The Reed 5A is the tangential pivoted tonearm below it, on the same Thales geometry but without a motor.

Spezifikationen