Hifiverse

Tonarme - Reed REED 5A

Beschreibung, Bilder, technische Daten und Spezifikationen

Reed REED 5A
Bildquelle - (c) Reed

The 5A is a tangential pivot tonearm from Reed, built in the Kaunas district of Lithuania, and the fourth model in the Reed tonearm range. Reed was founded by Vidmantas Triukas, a radio engineer working in audio since 1985, and made its first tonearm around 2008. The arm uses what Reed calls Double Birch/Thales geometry with 90-degree angling. In Reed's line it sits beside the laser-guided 5T, with the 1H, 2B, 2G and 3P as pivoted models.

Key specs that matter

Maximum tracking error is ±4 MOA (minutes of angle). Offset angle is 0 degrees and overhang is 0 mm. VTA adjustment has a precision of ±0.2 mm, and azimuth adjusts over ±8 degrees. Mounting distance is 251 mm, for platters up to 330 mm in diameter and 26-46 mm high. Downforce range is 10-30 mN, and cartridge mass is 5.5-19.5 g, with 4.0-25.0 g also listed. Effective mass is 8-16 g, depending on the armwand - wenge 10-14 g, Macassar ebony 10-16 g, cocobolo 12-16 g, light or dark teak 8-12 g. Headshells are Reed or SME type, on a universal connector. Finishes are Seashell white and black.

Engineering and use context

Reed compares the ±4 MOA figure with about 1.2-2.5 degrees for regular pivot tonearms. The 5A does not require anti-skating, and it needs no compressors or electronic controllers, and Reed describes it as compact and suitable for a wide range of turntables.

Its armtube suspension is similar to the system used in the Reed 3P. The back link runs on low-noise ceramic rolling bearings. On the lever a ceramic rolling bearing rests on a sapphire and molybdenum carbide thrust bearing, and the same type of thrust bearing is used on the front link and on the vertical and horizontal axes. An integrated level with a horizontal plane adjuster sets the arm to ±2 mm/m.

Pairing

A turntable that matches the listed mounting distance and platter height and diameter is required. The cartridge mass must fall within the listed range. Heavier armwands match low-compliance cartridges, lighter ones high-compliance cartridges.

Alternatives

The Reed 5T is the laser-guided, motor-driven tangential tonearm in the same Reed range.

Spezifikationen