The DX9 Discrete is a desktop DAC and headphone amplifier in the DX Series of TOPPING, a Chinese brand founded in 2008. Topping presents it as the second generation of the DX9, with the subtitle Fully Discrete 1 Bit. Where the original DX9 has an AK4499EQ converter, this model uses Topping's own 16-element PSRM DAC architecture. It also works as a preamplifier with variable balanced and single-ended outputs.
Key specs that matter
On USB and IIS, PCM is accepted up to 768 kHz/32-bit and DSD up to DSD512 native or DSD256 via DoP. Coaxial, optical and AES inputs take PCM up to 192 kHz/24-bit and DSD64 via DoP. Bluetooth codecs are AAC, SBC, aptX, aptX HD, aptX Adaptive and LDAC. Line Out THD+N is <0.00006% (XLR) and <0.00007% (RCA) at 1 kHz, A-weighted. SNR and dynamic range are 131 dB (XLR) and 128 dB (RCA). Frequency response is 20 Hz - 20 kHz (±0.6 dB) and 20 Hz - 40 kHz (±2.0 dB). Output level is 5.2 Vrms (XLR) and 2.5 Vrms (RCA) at 0 dBFS, and crosstalk is -136 dB (XLR) at 1 kHz. Headphone power is 7,080 mW x 2 into 32 ohms balanced and 2,120 mW x 2 single-ended (THD+N <1%), with output impedance <0.1 ohm. Size is 34.0 x 22.5 x 6.0 cm including protruding parts, and weight is 2.75 kg.
Engineering and use context
According to TOPPING, PSRM is a discrete 1-bit decoding design built from an ultra-fast switching logic array and precision voltage references. Each channel has a 16-element PSRM module, and the voltage references run from a pure resistive output supply. A CPLD digital processor paired with a precision clock performs dual-stage jitter purification. Coaxial, optical and AES inputs use an AK4118 receiver with jitter as low as 50 ps RMS, the USB input uses an XMOS XU316, and Bluetooth is provided by a Qualcomm QCC5125 module with an external antenna.
Volume is set by a fully balanced hybrid relay volume control that combines a relay-switched resistor network with digital volume control. Its headphone section uses six-channel discrete NFCA modules. DAC and headphone amplifier circuits are powered independently, from isolated switching power supply modules with low-noise voltage regulators, and a DC protection circuit is included. A ten-band PEQ and headphone crossfeed are available, and the Topping Tune software can store five custom PEQ profiles in the unit. Two 2.0-inch LCDs show Normal, VU or FFT pages.
Pairing
The front panel has 6.35 mm, 4.4 mm balanced and 4-pin XLR headphone jacks for loads above 8 ohms. For a preamplifier or integrated amplifier, the Line Out runs at a fixed 0 dB in DAC mode. The XLR and RCA PRE outputs connect to a power amplifier or active speakers, and a 12 V trigger in and out is provided.
Alternatives
TOPPING's DX5 II is a smaller DAC and headphone amplifier in the DX Series.