Hifiverse

DACs - Allnic Audio ASRA RD-7500

Beschreibung, Bilder, technische Daten und Spezifikationen

Allnic Audio ASRA RD-7500
Bildquelle - (c) Allnic Audio

The Allnic Audio ASRA RD-7500 is a digital-to-analog converter that hands the decoded signal to a single 5687 tube stage with neither an output transformer nor a coupling capacitor. Its name carries the ASRA prefix that Allnic also gives to the RHPA-7500 headphone and integrated amplifier, and the two share a 355 x 445 x 140 mm case. Designer Kang Su Park leads Allnic Audio in Korea, and Audio Mentors handles design and marketing for the brand.

Key specs that matter

Conversion is entrusted to the ESS ES9039PRO, a 32-bit chip that holds eight DAC channels and uses the fourth generation of the ESS HyperStream architecture. ESS specifies it at 132 dB of dynamic range per channel, 140 dB in mono mode and -122 dB THD+N in mono mode. The RD-7500 decodes PCM between 44.1 kHz and 384 kHz and DSD between DSD64 and DSD512. Signal-to-noise is 110 dB. Both the balanced XLR pair and the single-ended RCA pair present a 500 ohm source impedance.

Engineering and use context

Allnic sums up the aim of the design with the phrase straight wire with gain - the analog stage should make the converted signal larger and change nothing else. To keep the path short, the RD-7500 relies on a single amplification stage, where IC, transistor and multi-stage circuits route the signal through dozens of components. Allnic picked the 5687 dual triode because its linear behaviour, high transconductance and modest internal resistance together yield enough gain and a low output impedance from that single stage. The circuit has no negative feedback, and Allnic contrasts the two approaches by saying that feedback corrects an error after it happens, while its own method aims to keep the error from arising. Removing the output transformer takes its leakage inductance and distributed capacitance out of the high-frequency path, and dropping the coupling capacitor removes the reactance that causes phase shift in the bass. As a result the output stage is direct-coupled from DC up to frequencies well above the audible band.

Pairing

Line-level output from the RD-7500 travels over XLR when the receiving preamp or integrated amplifier has balanced inputs, and over RCA when it does not. Its moderate output impedance is comfortable with the high input impedance typical of tube line stages and of most solid-state amplifiers. A computer, network streamer or digital transport able to output high sample rates and multi-rate DSD can use the full format range. Together with an Allnic tube amplifier the system keeps vacuum tubes in every analog gain stage.

Alternatives

The Allnic Audio D-15000 Signature OTL/OCL is another Allnic converter that also pairs the ES9039PRO with a tube output stage free of transformers and capacitors.

Spezifikationen

  • Modellbezeichnung

    ASRA RD-7500

  • Wandlungstyp

    N/A

  • Wandlerchip

    N/A

  • DSD-Kompatibilität

    k. A.

  • Parameter

    PCM: 44.1kHz – 384kHz / DSD: DSD64 – DSD512

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Verstärkung (dBu)

    5

  • Ausgangspegel (symmetrisch) (V)

    N/A

  • Ausgangspegel (unsymmetrisch) (V)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (symmetrisch) (Ω)

    500

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    500

  • Analogausgänge

    N/A

  • Signal-Rausch-Abstand (dB)

    110

  • Klirrfaktor + Rauschen (% at 22 kHz)

    N/A

  • Abmessungen (mm)

    355 x 445 x 140

  • Gewicht (kg)

    N/A

  • Offizieller Link