Polk Audio's Signature Elite ES8 is the smallest of the three powered subwoofers in the Signature Elite series, below the ES10 and ES12. Polk aims it at compact home theaters, smaller music systems and apartments. In the United States it sells for USD 449, and it is offered in black only.
Key specs that matter
Bass comes from a single front-firing, high-excursion long-throw 203 mm woofer with a mineral-filled polypropylene cone. Its enclosure is vented through one internal Power Port. Amplification is Class D, rated at 100 W continuous (RMS). Frequency response is 32 Hz - 180 Hz (-3 dB) and 28 Hz - 400 Hz (-10 dB). Lowpass filter adjustment range is 50 Hz - 160 Hz, with an additional LFE setting, and phase is adjustable from -135° to +180° in 45° increments. Audio inputs are LFE (RCA) and stereo line level (2 x RCA). Item dimensions are 383 x 325 x 386 mm (H x W x D). Polk's info sheet gives the weight as 12.6 kg, and the owner's manual lists 13 kg.
Engineering and use context
According to Polk, the ported cabinet is rigidly built and reinforced with FEA-optimized internal bracing to minimize resonances. Its Power Port is front-facing, and Polk says it minimizes turbulence and reduces noise and distortion. Its feet are permanently installed, with no levelling.
Inside, a DSP works at 32-bit floating point resolution and uses group delay-minimizing filters and precision limiters. An adjustable 4th-order lowpass filter sets the upper limit. With Time-Smart Phase Control, phase covers 360 degrees around the lowpass filter setting. Plugging a cable into the LFE input puts the ES8 into LFE mode automatically, its lowpass filter is then bypassed, and the crossover is set in the AV receiver.
All adjustments are made with +/- pushbuttons on the back panel - volume from 1 to 40, lowpass frequency and phase - and LED status lights indicate each value. From the factory it is set to volume 20, 80 Hz and 0 degrees. An Auto On / Always On switch selects how the ES8 powers up. With Auto On it leaves standby when an audio signal arrives and goes back into standby about 20 minutes after the signal stops. A Power-Save Mode with an auto-sensing power supply lowers consumption when the subwoofer is idle. Main power is switched by an on/off rocker, and the grille is detachable.
Pairing
The LFE input is for an AV receiver with a dedicated LFE channel or subwoofer pre-out. In a 2-channel system the line inputs require a post-volume left and right pre-out. Speaker-level inputs are not provided.
Alternatives
The Signature Elite ES10 is the next model up, with a 254 mm woofer, two Power Ports and a 200 W amplifier.