Hifiverse

Subwoofer - Klipsch R-120SW

Beschreibung, Bilder, technische Daten und Spezifikationen

Klipsch R-120SW
Bildquelle - (c) Klipsch

The R-120SW is the 305 mm powered subwoofer of the Klipsch Reference series, built from 2018 and sold alongside the 254 mm R-100SW. Both models share one owner's manual. In the 2021 revision of the range Klipsch replaced it with the R-121SW. It has a front-firing spun-copper IMG woofer, an all-digital amplifier and a reflex-loaded MDF cabinet.

Key specs that matter

Driver complement is one 305 mm high excursion spun-copper IMG woofer, front-firing. The all-digital amplifier is rated at 200 W continuous and 400 W peak. Frequency response is 29 Hz - 120 Hz (±3 dB), and maximum acoustic output is 116 dB. Enclosure type is bass reflex via a rear-firing port, with MDF as the enclosure material. Inputs are line level/LFE RCA jacks. Dimensions are 419 x 356 x 488 mm (H x W x D), and weight is 14.1 kg. Finish is black textured wood grain vinyl.

Engineering and use context

IMG stands for Injection Molded Graphite. Klipsch describes these woofers as light and rigid, with minimal cone breakup and distortion. Its cabinet is wrapped in a scratch-resistant textured wood grain vinyl, and a low profile grille covers the front.

On the amplifier panel there are volume, low-pass and 0/180 degree phase controls. With the low-pass knob turned fully clockwise the filter sits at 160 Hz, the position Klipsch specifies when the crossover is set in the receiver. A three-position switch selects Off, Auto or On. In Auto the subwoofer turns on when it senses a signal and goes into standby after 15-20 minutes with no signal, while On keeps it running until switched manually. A power LED on the front baffle shows the operating status of the built-in amplifier, with green indicating that it is on and has an input signal.

The two RCA inputs are labelled LEFT/LFE and RIGHT. A single cable from a subwoofer pre-out or LFE output goes to the LEFT/LFE jack, and this connection serves both music and surround sound. Without a subwoofer output, the left and right pre-amp outputs connect to both jacks.

Pairing

A receiver, processor or preamplifier with an LFE output or left and right pre-outs is required. Speaker-level inputs are not provided. The matching main speakers are the Klipsch Reference floorstanding, bookshelf and centre models of the same generation.

Alternatives

The Klipsch R-100SW is the smaller IMG subwoofer of the same 2018 Reference generation, with a 254 mm woofer.

Spezifikationen

  • Modellbezeichnung

    R-120SW

  • Untere Grenzfrequenz +/- 3dB (Hz)

    29

  • Obere Grenzfrequenz +/- 3dB (Hz)

    120

  • Empfindlichkeit (dB at 1 W/1m)

    N/A

  • Impedanz (Ohms)

    N/A

  • Verfügt über interne Verstärkung

    Ja

  • Endverstärker (W)

    200 - 400

  • Größe (sm)

    41.9 × 35.6 × 48.8

  • Gewicht (kg)

    14.1

  • Offizieller Link