The R-100SW is a powered subwoofer from the 2018 generation of the Klipsch Reference series. Klipsch was founded in 1946 by Paul W. Klipsch and is based in Indianapolis. In the 2018 range the R-100SW is the 254 mm woofer model below the R-120SW, and Klipsch now lists the newer R-101SW as its successor. The cabinet is finished in black textured wood grain vinyl with a scratch-resistant surface.
Key specs that matter
A single 254 mm high-excursion spun-copper IMG (Injection Molded Graphite) woofer is front-firing. Amplification is all-digital, rated at 150 W continuous and 300 W peak. Frequency response is 32 - 120 Hz (±3 dB), and maximum acoustic output is 112 dB. The MDF enclosure is bass reflex via a rear-firing port. Inputs are line level/LFE RCA jacks. Dimensions are 368 x 318 x 417 mm (H x W x D), and weight is 10.9 kg.
Engineering and use context
According to Klipsch, IMG cones are light and rigid, with minimal cone breakup and distortion at low frequencies. Klipsch specifies the built-in amplifier as a high-efficiency all-digital design.
Amplifier features are volume, a variable low-pass filter, a 0/180 degree phase switch and Auto Power On. On the low-pass control the farthest clockwise position is 160 Hz. Its Off/Auto/On switch has three positions. In Auto the subwoofer turns on when it senses a signal and goes into standby mode after 15 - 20 minutes with no signal. On keeps it running until the switch is moved, and Off keeps it off. A power LED on the front baffle shows the operating status of the built-in amplifier and lights green when the amplifier is on and receiving a signal. Klipsch describes the low-profile grille as acoustically transparent.
Each of the two RCA line inputs is labelled, one LEFT/LFE and one R. A single subwoofer cable from the Sub Out or LFE output of a surround receiver or processor goes to the LEFT/LFE input. Without a subwoofer output, the left and right pre-amp outputs of a receiver or preamplifier connect to both inputs.
Pairing
A surround receiver or processor with a line-level subwoofer output, or a stereo preamplifier with left and right pre-outs, is required. Klipsch intends the low-pass and phase controls for blending with other Klipsch speakers. When the receiver sets the crossover point, the low-pass knob on the R-100SW is turned to 160 Hz.
Alternatives
The R-101SW is the later Reference subwoofer with a 254 mm spun-copper TCP woofer, a 29.5 Hz lower limit and 115 dB maximum output.