Hifiverse

Standlautsprecher - T+A Solitaire S 430

Beschreibung, Bilder, technische Daten und Spezifikationen

T+A Solitaire S 430
Bildquelle - (c) T+A

The Solitaire S 430 is a three-way floorstanding loudspeaker from T+A elektroakustik of Herford, Germany, and T+A describes it as the entry into its High-End reference loudspeakers. It sits in the Solitaire S series below the S 530 and S 540, and listings from 2023 gave EUR 25,000, GBP 23,500 or USD 29,900 per pair.

Key specs that matter

Design is three-way bass reflex. Drive units are two 220 mm bass drivers, two 150 mm midrange drivers and one 50 mm Mag50 magnetostat, with crossover frequencies of 200 Hz and 2.2 kHz. Frequency range is 29 Hz - 45 kHz, sensitivity is 86 dB (1 W/1 m) and impedance is 4 ohms. Power rating is 200 W nominal and 250 W music power. Dimensions are 1180 x 260 x 440 mm (H x W x D) including the base, and weight is 55 kg.

Engineering and use context

The Mag50 is hand-made, developed and produced in Herford, and is based on the transducers of T+A's TPM 3100 and TPM 2500 headphones. Its WaveArray conductor is aluminium etched onto a carrier film by a photo-chemical process, with a slightly undulating conductor path calculated against linear modes. Ten magnets sit in two rows along its 50 mm length, and a Draft Control System adopted from the Solitaire P-SE headphone reduces turbulence at the magnets. Unlike an electrostat, it needs no supplementary power supply.

In T+A's Symmetric Directivity system the two aluminium StarStabilizer midrange drivers are positioned above and below the concentric magnetostat. According to T+A, two drivers halve the excursion of each, and the arrangement reduces reflections from ceiling and walls. Both 220 mm bass units are aluminium long-throw drivers with StarStabilizer protection against diaphragm break-up, loaded by a large cross-section bass reflex system. The front baffle is machined from solid aluminium.

Crossovers are double-sided Fast Signal Response (FSR) three-way boards with a dedicated earth layer, and their filter stages are optimised for phase and group delay. T+A uses its own coaxial cable for the magnetostat connection. Bass and midrange boards are completely separate. On the rear terminal, BASS, MID and TREBLE switches each give +1.5 dB, LIN or -1.5 dB. Spikes with floor contact plates, base plates, transport rollers and protection grilles are supplied. Finishes are high-gloss black, Macassar and Arctic Silver.

Pairing

An amplifier stable into 4 ohms is required. The separate bass and mid/treble boards allow bi-wiring or bi-amping.

Alternatives

The Solitaire S 530 is the next T+A floorstanding speaker in the series, with an 850 mm Mag850 magnetostat and seven midrange drivers.

Spezifikationen

Weitere Komponenten