Hifiverse

Standlautsprecher - Piega MASTER LINE SOURCE 2 GEN2

Beschreibung, Bilder, technische Daten und Spezifikationen

Piega MASTER LINE SOURCE 2 GEN2
Bildquelle - (c) Piega

The Master Line Source 2 Gen2 is a 3-way dipole floorstanding loudspeaker with acoustic lens from Piega's Master series. Piega has made its loudspeakers by hand since 1986, and the family-run company is still based on the shores of Lake Zurich. In the Master series the MLS 2 Gen2 sits between the Master Line Source MKII and the Master Line Source 3. The Gen2 version made its debut at High End Munich. Roger Kessler, Piega's head of research and development, developed it, and its design comes from Stephan Hürlemann.

Key specs that matter

Its driver complement is four line source drivers 211, two 220 mm UHQD bass units and two 220 mm UHQD passive membranes on the rear. Frequency response is 20 Hz - 50 kHz. Sensitivity is 92 dB/W/m, and impedance is 4 ohms. Recommended amplifier output is 20 - 500 W. Each speaker measures 168 x 29 x 45.5 cm (H x W x D) and weighs 98 kg. Versions are a brushed aluminium baffle anodised silver or black with a matt cabinet lacquered in the same colour, a white-lacquered aluminium baffle with a matt white cabinet, and a black anodised baffle with a Zebrano veneer cabinet.

Engineering and use context

Each line source driver is a ribbon with a wafer-thin aluminium foil diaphragm and several flat coils, etched out in a spray-etching process. At 20 µm thick, the membrane acts as the voice coil and as the driver at the same time. Its moving mass of 7 mg is driven by neodymium magnets. Four of these ribbons are stacked into a line, and Piega states that the symmetric array of the midrange improves the horizontal radiation pattern. Its wavefront expands vertically in a cylindrical shape, with no reflection from the ceiling or the floor.

On the back, black-lacquered lamellae form an acoustic lens. Using diffraction and reflection, it turns the backward radiation into a diffuse sound field. The line source drivers are mounted on a 10 mm thick aluminium baffle that is fully bonded to the enclosure, a rigid cabinet with matrix strut. Both the UHQD woofers and the passive membranes use aluminium membranes, which Piega describes as rigid and ultralight with low mechanical loss.

Pairing

An amplifier stable into 4 ohms is required. The terminals allow bi-wiring or connection through the PIEGA multi connector.

Alternatives

The Master Line Source 3 is the smaller dipole line source loudspeaker in Piega's Master series.

Spezifikationen

  • Modellbezeichnung

    MASTER LINE SOURCE 2 GEN2

  • Untere Grenzfrequenz +/- 3dB (Hz)

    20

  • Obere Grenzfrequenz +/- 3dB (Hz)

    50 000

  • Empfindlichkeit (dB at 1 W/1m)

    92

  • Impedanz (Ohms)

    4

  • Anforderungen an den Endverstärker (W)

    20 - 500

  • Verfügt über interne Verstärkung

    k. A.

  • Leistung der internen Verstärkung (W)

    N/A

  • Größe (sm)

    168 × 29 × 45.5

  • Gewicht (kg)

    98

  • Offizieller Link

Weitere Komponenten