Fyne Audio's flagship floorstanding speaker, the F1-12S is the evolution of the earlier F1-12. The F1 Series runs from the F1-5 bookshelf model upwards, and every unit is designed, manufactured, hand finished and tested at Fyne's Glasgow facility. For the S version Dr Paul Mills and his team reworked the crossover and upgraded the 300 mm IsoFlare driver with FyneFlute technology. The UK price is GBP 37,999.99 per pair including VAT, with Piano Gloss Walnut as the only finish.
Key specs that matter
System type is two-way, with a port that vents downwards onto a BassTrax Tractrix diffuser. Drive unit complement is one 300 mm IsoFlare point source driver with a FyneFlute surround, a multi-fibre bass/midrange cone and a 75 mm titanium dome compression tweeter on a neodymium magnet system. Crossover frequency is 750 Hz. Sensitivity is 96 dB (2.83 V/1 m) and nominal impedance is 8 ohms. Frequency response is 24 Hz - 26 kHz (-6 dB, typical in room). Recommended amplifier power is 20 - 350 W RMS, continuous power handling is 175 W RMS and peak power handling is 600 W. Front-panel controls adjust 750 Hz - 26 kHz and 2.5 - 5.0 kHz by ±3 dB each. Dimensions are 1350 x 450 x 680 mm (H x W x D, plinth included, spikes excluded), and weight is 72 kg.
Engineering and use context
A vented rear chamber in the neodymium HF magnet places the resonance of the compression unit well below the crossover region. Fyne states that it enables the low 750 Hz crossover point. In the LF section a ferrite magnet drives a rectangular copper voice coil on an aluminium former, and a copper shorting ring on the pole piece reduces eddy currents. The cast aluminium chassis is coupled to the internal bracing through damping material.
Pressed high density birch ply with solid wood trim and extensive internal bracing forms the cabinet. Twin cavity reflex loading broadens the tuning frequency to reduce cone excursion, and a 20 kg machined aluminium plinth houses the diffuser, which converts the port output into a 360-degree wavefront.
Crossover parts, hard wired on fibre board panels, include laminated iron core inductors and Claritycap polypropylene capacitors. An autotransformer with silicon steel laminations matches the impedance of the compression driver to the amplifier. Neotech PC-OCC wiring runs to WBT Nextgen bi-wire terminals, and a grounding terminal reduces radio frequency interference.
Pairing
The terminals allow bi-wiring or bi-amping with two stereo power amplifiers or four monoblocks. Fyne states that single-ended triode tube amplifiers below the minimum recommended power can be used, with restricted maximum volume.
Alternatives
The Fyne Audio F1-10S is the smaller F1 floorstanding speaker, with a 250 mm IsoFlare driver, 94 dB sensitivity and a weight of 57.7 kg.