The Vintage Twelve is a floorstanding loudspeaker in the Vintage Series from Fyne Audio, which also includes the Vintage Five, Ten and Fifteen. Fyne describes it as bringing the scale of the F1-12S into the traditional Vintage design. According to Fyne, the series takes technology first developed by Dr Paul Mills for the F1 Series into period cabinet designs. UK price is GBP 22,999.99 per pair in walnut.
Key specs that matter
This is a two-way design with a port facing the floor and a BassTrax Tractrix diffuser. Its drive unit complement is one 300 mm IsoFlare point source driver with a multi-fibre bass/midrange cone and a 75 mm titanium alloy dome compression tweeter with a neodymium magnet system. Crossover frequency is 750 Hz. Sensitivity is 96 dB (2.83 V/1 m), and nominal impedance is 8 ohms. Frequency response is 24 Hz - 26 kHz (-6 dB, typical in room). Recommended amplifier power is 20 - 350 W RMS, continuous power handling is 175 W RMS and peak power handling is 700 W. Dimensions are 1102 x 572 x 591 mm (H x W x D), and net weight is 77.1 kg each.
Engineering and use context
Both sections of the IsoFlare driver share a common centre on a cast aluminium chassis. Behind the titanium diaphragm, a vented rear chamber in the neodymium HF magnet places low frequency resonance below the crossover region. Its annular waveguide has a computer optimised expansion rate, and the edgewound aluminium voice coil is wound on a Kapton former. On the LF side, a multifibre paper cone with FyneFlute surround is driven by a ferrite magnet and a rectangular copper voice coil on an aluminium former, with a copper shorting ring on the pole piece.
Its twin cavity reflex system vents through the base onto the patented Tractrix profile diffuser, which converts the output into a 360-degree wavefront. Cabinets are high density birch ply with extensive internal bracing, and the drive unit is coupled to the bracing panels through damping material. Finishes are Walnut and Burr Walnut veneer with gold anodised metalwork.
Each crossover is bi-wired passive low loss with 2nd order low and high pass slopes. Laminated iron core LF inductors, thick film resistors and polypropylene HF capacitors are hard wired on fibre board panels, and the complete crossover is cryogenically treated. An autotransformer matches the HF compression driver to the amplifier. Terminals are WBT Nextgen, internal wiring is OFC, and two controls, one a front mounted analogue dial, adjust the 750 Hz - 26 kHz and 2.5 - 5 kHz bands by ±3 dB each.
Pairing
The WBT terminals allow single-wire, bi-wire or bi-amp connection. A grounding terminal connects to the amplifier earth.
Alternatives
The Vintage Ten is the model below, with a 250 mm IsoFlare driver, 94 dB sensitivity and a 1040 mm tall cabinet.