The V4 Series 4 is a two-way, full-range active studio reference monitor from KRK Systems, intended for recording, mixing and mastering. It is the smallest of the three near-field monitors in the fourth-generation V Series, which spans 85 to 230 W of amplification across the V4, V6 and V8. KRK presented the series in 2016, and the V4 was launched at USD 399.
Key specs that matter
Both drive units are custom designed by KRK. A 102 mm woven Kevlar woofer with a cast aluminium frame and a ferrite magnet works with a 25 mm Kevlar dome tweeter, also on a ferrite magnet. Crossover frequency is 2.1 kHz. Frequency response is 58 Hz - 19 kHz (±3 dB), and frequency range is 50 Hz - 24 kHz (-10 dB). Amplification is bi-amped class D - 55 W LF and 30 W HF, 85 W in total. Peak SPL is 110 dB. Connectors are a balanced 10 kohm XLR / 6.35 mm combo input and an IEC power inlet. The MDF and aluminium enclosure measures 256 x 166 x 218 mm (H x W x D) and weighs 5.8 kg.
Engineering and use context
Each driver has its own dedicated class D amplifier. The bass reflex enclosure is front-ported, and KRK states that this avoids boundary coupling. An EVA foam cushion on the bottom and the cast-aluminium front form a built-in stabiliser that, according to KRK, reduces woofer recoil, and the foam isolates the monitor from the desk.
On the rear panel, level attenuation starts at zero and reduces output in 0.5 dB steps down to -3 dB for level matching with other monitors. System switches select ground lift, input sensitivity, standby and the front logo LED, on or off and dim or bright. According to KRK, input sensitivity is a pad rather than a volume control - the amplifier runs wide open, and the +4 dBu position gives more dynamic range and a lower noise floor than -10 dBV, the factory setting.
At power-up there is a 3-second delay before the logo lights, and signal reaches the drivers one second later. With standby engaged, the monitor goes to sleep 30 minutes after the last signal, the logo pulses, and it wakes once the input exceeds -50 dBu. Protection covers AC power surges, amplifier overdrive and overheating. A USB jack is reserved for possible future updates, and universal threaded points accept wall-mounting brackets. Supplied with it are a power cable, a custom KRK adjustment key and an optional protective grille with screws. This grille mounts on the aluminium baffle beneath the brushed faceplate, which is held by six cap-head screws.
Pairing
A balanced line-level output from an audio interface, mixing console or monitor controller is required. KRK specifies the +4 dBu setting for most professional equipment.
Alternatives
The V6 Series 4 is the next size up, with a 165 mm woven Kevlar woofer and 155 W of bi-amped class D power.