The SCM20PSL Pro is a compact passive two-way studio monitor from ATC, designed and manufactured at Aston Down near Stroud in Gloucestershire. In the two-model SCM20 Pro series the PSL suffix marks the passive unit and the ASL suffix the active version. ATC intends it for critical near-field listening in all control rooms, LCR surround monitoring in small-to-medium control rooms and surround channels in medium-to-large control rooms. Its current version is the MkII, and the warranty runs for six years.
Key specs that matter
Drive units are ATC's own 150 mm (6.5 in.) Super Linear mid/bass driver with a 75 mm (3 in.) voice coil, the SB75-150SL (8 ohms), and a 25 mm (1 in.) dual suspension soft dome tweeter, the SH25-76S (6 ohms). Crossover frequency is 2.5 kHz. Amplitude linearity is 80 Hz - 20 kHz (±2 dB), and cut-off frequencies are 55 Hz - 25 kHz (-6 dB, freestanding). Dispersion is ±80° coherent horizontal and ±10° coherent vertical. Maximum continuous SPL is 108 dB (per pair at 1 m). Nominal impedance is 8 ohms, and recommended amplifier power is 75 - 300 W. Connectors are two pairs of binding posts for 4 mm plugs. Cabinet dimensions are 450 x 250 x 294 mm (H x W x D), and weight is 18 kg per cabinet.
Engineering and use context
ATC attributes the low distortion and the wide effective dynamic range of the monitor in part to Super Linear technology and the underhung voice coil construction of the mid/bass driver. According to the maker, the extended low frequency response comes at the cost of relatively low sensitivity, the usual trade-off in a passive loudspeaker.
On the bi-wire connection panel the upper horizontal pair of terminals is connected to the tweeter and the lower pair to the bass driver, with linking bars between the vertical pairs. The terminals accept stripped bare cable ends, 4 mm banana plugs or spade terminals. ATC specifies speaker cable of at least 2.5 mm2 per conductor, and a heavier gauge for runs longer than 5 m. For wall mounting ATC lists the K&M 24120 Wall Mount, which requires a modification of the cabinet to accept the top-hat mount.
Pairing
ATC advises an amplifier capable of more than 150 W continuous into 8 ohms. ATC advises care with high output impedance amplifiers, tube or solid-state. The terminals allow bi-wiring or passive bi-amping once the linking bars are removed.
Alternatives
ATC's SCM12 Pro is a compact two-way studio monitor with a 150 mm constrained layer damping (CLD) mid/bass driver.