The R1280DBs is Edifier's revision of the R1280DB, an active Bluetooth bookshelf speaker system with an active and a passive speaker. Compared with the earlier model it adds a Sub Out port with subwoofer detection and a sound field extension mode, and Edifier quotes a lower bass limit. The pair was listed at USD 199.99 in brown or black.
Key specs that matter
Total output power is 21 W + 21 W RMS, 42 W for the pair. Each speaker has a 116 mm mid-range/bass driver and a 13 mm silk diaphragm treble driver, divided by a 2-way active crossover. Frequency response is 51 Hz - 20 kHz, and signal-to-noise ratio is ≥85 dB(A). Input sensitivity is 500 ± 50 mV on Line In 1, 600 ± 50 mV on Line In 2, 350 ± 50 mFFS on optical and coaxial and 700 ± 50 mFFS over Bluetooth. Each speaker measures 146 x 234 x 196 mm (W x H x D) and weighs 4.9 kg net.
Engineering and use context
Edifier uses wooden enclosures to isolate acoustic resonance, and the bass reflex port faces forward. The Sub Out port of the active speaker has a detection function. When a subwoofer is connected, the speakers' own bass is reduced and the bass is output mainly by the subwoofer, turning the pair into a 2.1 system.
Wireless reception uses Qualcomm Bluetooth with the A2DP and AVRCP profiles, an effective range of 10 m and a PIN code of 0000 where needed. Optical and coaxial inputs decode PCM at 44.1 kHz or 48 kHz only. Treble, bass and master volume dials are on the side panel of the active speaker. A press on the master volume control switches inputs, while holding it powers the system on or off, or disconnects Bluetooth in Bluetooth mode. Its input indicator is green for the line inputs, red for optical or coaxial and blue for Bluetooth. The RC80B remote control has power, mute, volume, input and Bluetooth playback buttons, plus separate buttons that enable and disable sound field extension, and uses a CR2032 cell. Supplied cables are the speaker connecting cable, a 3.5 mm to RCA cable, an RCA to RCA cable and a fiber optic cable, while a coaxial cable is not included.
Pairing
A powered subwoofer with a line-level input matches the Sub Out port. A digital source with PCM output at 44.1 kHz or 48 kHz is required for the optical and coaxial inputs. A turntable requires an external phono stage.
Alternatives
The Edifier R1280DB has the same drivers and power rating, with Bluetooth 5.1 and no subwoofer output.