The PMC6 is an active two-way nearfield reference monitor with ATL bass loading in the studio range of PMC, based in Biggleswade, England. PMC intends it for smaller control rooms and for use in larger multichannel systems. It can stand upright or lie on its side, and a PMC8 SUB can be added later to form a PMC6 XBD system with LF extension down to 25 Hz.
Key specs that matter
Its bass unit is a PMC 150 mm studio 6 driver with 20 mm of excursion, used with a PMC 27 mm soft dome tweeter. Each driver has its own 200 W rms Class-D amplifier. Effective ATL length is 1.8 m. Frequency response is 39 Hz - 25 kHz (-3 dB, 1 m, full space, on-axis), and sensitivity is +4 dBu input = 98 dB SPL at 1 m. Maximum continuous SPL is 106 dB and peak SPL 118 dB at 1 m. Directivity is ±60 degrees horizontal and +50/-40 degrees vertical (-6 dB at 10 kHz). Upright, the cabinet measures 400 x 215 x 372 mm (H x W x D), and it weighs 11.1 kg.
Engineering and use context
PMC designed the 150 mm bass driver specifically to integrate with its latest ATL bass loading and Laminair airflow technology. Its fabric soft-dome tweeter sits in a shallow waveguide for wide dispersion. Both amplifiers are ultra-low-distortion, high-damping-factor Class-D designs. In upright or horizontal placement the DSP engine adjusts the crossover automatically, and orientation can also be set manually. Other DSP functions are a ±10 dB level trim, a 20 - 200 Hz high-pass filter at 12 dB per octave, 0 - 30 ms delay, normal or inverted phase, LF and HF shelving filters, five-band parametric EQ and three user presets, with 2.4 ms latency. Calibration is done from the rear-panel controls or through the browser-based SoundAlign software over the RJ45 network port.
Mains input is 100 - 240 V AC auto-switching through an IEC C14 socket, with 35 W consumption at idle and 400 W maximum. A ceiling-mount yoke allows suspension in multichannel systems, and an expansion card slot is reserved for future connectivity upgrades.
Pairing
The XLR input switches between analogue up to +20 or +24 dBu at 22 kOhm and AES3 digital at 16 or 24-bit, 18 - 192 kHz. A digital AES3 through output at 24-bit, 96 kHz links the next speaker or a sub. An audio interface, monitor controller or console is required, and no external amplifier is needed.
Alternatives
The PMC result6 is the simpler two-way active nearfield in the studio range, with an analogue crossover, a 170 mm bass driver and no DSP user options.