Hifiverse

Regallautsprecher - Fyne Audio F300I

Beschreibung, Bilder, technische Daten und Spezifikationen

Fyne Audio F300I
Bildquelle - (c) Fyne Audio

The F300i is the smaller of the two bookshelf models in the F300i series from Fyne Audio. It builds on the original F300 with an improved titanium tweeter and an upgraded crossover. Fyne lists both stereo hi-fi and home theatre applications for it. At GBP 250 per pair it is the entry point of a line-up that also includes the F301i standmount at GBP 349.99, the F302i and F303i floorstanding speakers at GBP 599.99 and GBP 799.99, and the F300i LCR centre speaker at GBP 199.99.

Key specs that matter

System type is 2-way, rear ported. Drive units are one 125 mm multi-fibre bass/mid driver and one 25 mm titanium dome tweeter, crossed over at 3.4 kHz. The crossover is 2nd order low pass and 3rd order high pass. Sensitivity is 87 dB (2.83 V/1 m), and nominal impedance is 8 ohms. Frequency response is 54 Hz - 34 kHz (-6 dB, typical in room). Recommended amplifier power is 20 - 70 W RMS, with continuous power handling of 35 W RMS. Dimensions are 250 x 156 x 211 mm (H x W x D), and net weight is 3.7 kg. Finishes are Walnut, Black Ash and Light Oak.

Engineering and use context

On the bass/mid driver, a multi-fibre paper cone carries a phase plug at its centre. Fyne specifies this plug for smooth midrange roll-off characteristics. Its roll rubber surround uses FyneFlute technology, a non-homogeneous interface intended to terminate cone energy. Behind the 25 mm titanium dome tweeter is a Neodymium magnet system. Integrated in the protective mesh cover, a phase loss compensator delays the output from specific areas of the dome.

Cabinets use MDF panels that are cross-braced internally. The magnet of the low frequency driver is coupled to this bracing with a resonant absorbing mastic. In the crossover Fyne uses a low loss laminated core inductor on the LF side and polypropylene capacitors on the HF side. The network was computer optimised and then fine tuned by auditioning. Single gold plated speaker terminals are on the rear, and in this range only the F303i has bi-wire terminals.

A bracket engineered into the rear panel allows the F300i to be flush-mounted to a wall. Fyne points to this for rear effects use in a home cinema system.

Pairing

An amplifier rated for 8 ohm loads within the recommended power range is required. In a home theatre system the matching centre speaker is the F300i LCR.

Alternatives

The F301i is the larger bookshelf model of the same F300i series.

Spezifikationen

  • Modellbezeichnung

    F300I

  • Untere Grenzfrequenz +/- 3dB (Hz)

    54

  • Obere Grenzfrequenz +/- 3dB (Hz)

    34 000

  • Empfindlichkeit (dB at 1 W/1m)

    87

  • Impedanz (Ohms)

    8

  • Anforderungen an den Endverstärker (W)

    20 - 70

  • Verfügt über interne Verstärkung

    k. A.

  • Leistung der internen Verstärkung (W)

    N/A

  • Größe (sm)

    25.0 x 15.6 x 21.1

  • Gewicht (kg)

    3.7

  • Offizieller Link

Weitere Komponenten