The TR-1100 is an open-reel tape recorder from Analog Audio Design of Pleumeur-Bodou in Brittany, the French company founded by engineer Christophe Martinez that began with the playback-only TP-1000. Unlike the TP-1000 and TP-1100 players, it records as well as plays back. Analog Audio Design presents it after five years of development and lists it as available from November 2026. International pricing had not been published at announcement.
Key specs that matter
It takes 6.35 mm tape in the 2-track, 2-channel format with a DIN track width of 2.7 mm, on reels up to 30 cm. Tape speeds are 30 ips (76.2 cm/s), 15 ips (38.1 cm/s) and 7.5 ips (19.05 cm/s), switchable, with speed accuracy within ±0.05% and a pitch control range of ±100% at 0.01 ips resolution. Wow and flutter, weighted to DIN 45507, is below 0.030% peak at 30 ips, 0.045% peak at 15 ips and 0.09% peak at 7.5 ips. Frequency response at 0 VU is 30 Hz - 25 kHz (30 ips), 30 Hz - 22 kHz (15 ips) and 30 Hz - 20 kHz (7.5 ips), all ±2 dB. Signal-to-noise ratio (THD-N/A-weighted) is 71/78 dB at 30 and 15 ips and 70/77 dB at 7.5 ips. Bias frequency is 180 kHz. Erasure is 70 dB or more (1 kHz, 320 nWb/m) with a 90 kHz erase frequency. Distortion is 0.8% or less at 1 kHz and 15 ips, and channel crosstalk is 60 dB or more. The recorder measures 466 x 519 x 305 mm (W x H x D) and weighs 28.5 kg.
Engineering and use context
This recorder incorporates a wave generator and an audio analyzer for automatic calibration of bias, recording level and equalization. NAB and IEC equalization are switchable, as is the reproduce/record reference level of 320 or 514 nWb/m. Frequency response depends on the type of magnetic head installed, Analog Audio Design notes. Its capstan is driven by a DC servo motor through a belt, and both reels have direct drive servo motors. Fast wind has three preset speeds of 2, 6 and 10 m/s, plus control from 1 to 12 m/s in 1 m/s steps. Mains input is an IEC 3-pole connector for 90 - 264 VAC at 47 - 63 Hz, and power consumption is 250 W maximum.
Pairing
Input and output are on XLR connectors, each selectable for balanced +4 dBu or unbalanced -10 dBV, and a bypass XLR is provided. An RJ45 10/100Base-T port is used for remote control and firmware updates, alongside an infrared remote input. The headphone output is rated at 1.5 W maximum into 8 ohms.
Alternatives
The TP-1100 from the same maker shares the three-speed transport but is a playback-only tape player.