Hifiverse

Sonstige Geräte - Analog Audio Design TP-1100

Beschreibung, Bilder, technische Daten und Spezifikationen

Analog Audio Design TP-1100
Bildquelle - (c) Analog Audio Design

The TP-1100 is an open-reel tape player from Analog Audio Design, the French company that engineer Christophe Martinez started in Pleumeur-Bodou, Brittany. Its first machine, the TP-1000 player, followed four years of development. The TP-1100 keeps the playback-only concept of the TP-1000 and adds direct drive reel motors, a third tape speed of 30 ips and an XLR bypass output. An updated version was presented in March 2026, and the current catalogue also lists the TR-1100 recorder and a TP-1000 Gold Edition.

Key specs that matter

Tape is 6.35 mm in 2-track, 2-channel format, with a DIN track width of 2.7 mm and a maximum reel size of 30 cm. Three switchable tape speeds are available - 30 ips (76.2 cm/s), 15 ips (38.1 cm/s) and 7.5 ips (19.05 cm/s). Tape speed accuracy is within ±0.05%, and the pitch control range is ±100% with a resolution of 0.01 ips. Wow and flutter is below 0.030% peak at 30 ips, 0.045% peak at 15 ips and 0.09% peak at 7.5 ips (weighted, DIN 45507). Frequency response is 30 Hz - 25 kHz at 30 ips, 30 Hz - 22 kHz at 15 ips and 30 Hz - 20 kHz at 7.5 ips (±2 dB, 0 VU). Signal-to-noise ratio is 71 dB THD-N and 78 dB A-weighted at 30 and 15 ips, and 70 dB and 77 dB at 7.5 ips. Distortion is 0.8% or less (1 kHz, 15 ips), and channel crosstalk is 60 dB or more. Dimensions are 466 x 519 x 305 mm (W x H x D), and weight is 28.5 kg.

Engineering and use context

A DC servo motor with belt drive turns the capstan, while each reel sits on its own direct drive servo motor. Wind speed switches between 2, 6 and 10 m/s, and manual wind speed control runs from 1 to 12 m/s in 1 m/s steps. Equalization is switchable between NAB and IEC. Reproduce reference level is 320 or 514 nWb/m, also switchable. According to Analog Audio Design, the frequency response depends on the type of magnetic head installed. On the power side, an IEC 3-pole connector accepts 90 - 264 VAC at 47 - 63 Hz, and consumption is 250 W maximum. Remote control and firmware updates run over an RJ45 10/100Base-T Ethernet port, and an IR input accepts the RC-1000 remote control, which is sold as an accessory together with a rack-mount kit.

Pairing

Line outputs use XLR connectors, switchable between balanced +4 dBu and unbalanced -10 dBV. A separate bypass output is also on XLR. The headphone output gives 1.5 W maximum into an 8 ohm load.

Alternatives

The TP-1000 is the earlier Analog Audio Design player, with two tape speeds of 15 and 7.5 ips and belt-driven DC reel motors.

Spezifikationen