Hifiverse

Vorverstärker - Vincent SA-T7MK

Beschreibung, Bilder, technische Daten und Spezifikationen

Vincent SA-T7MK
Bildquelle - (c) Vincent

The SA-T7MK is a stereo tube preamplifier in the tubeLine range of Vincent and the revised version of the SA-T7, which the company calls its reference preamplifier. Its MK update brought a modernised front panel without the chrome rings and a Bluetooth 5.0 input. Vincent states that the SA-T7MK is developed and finally assembled in Germany. It is available in black or silver.

Key specs that matter

The tube complement is four 6SCH9P, four 6SCH51P and one 85A2. Inputs are six stereo RCA line inputs, one optical, one coaxial and Bluetooth. Outputs are two stereo RCA pre-outs, one stereo RCA rec-out and two 3.5 mm jacks for 12 V power control. Frequency response is 10 Hz - 100 kHz (±0.1 dB). Gain is typically 13.3 dB at maximum volume, and input sensitivity is 430 mV for 2 V output. Nominal output voltage is 3 V. THD is below 0.001% (1 kHz, 2 V rms into 10 kOhm). Signal-to-noise ratio is typically above 100 dB (A). Input impedance is above 22 kOhm. Maximum power consumption is 58 W. Dimensions are 430 x 135 x 370 mm (W x H x D), and weight is 8.5 kg.

Engineering and use context

Its gain stage uses the BestPentode circuit by Dipl.-Ing. Frank Blöhbaum. According to Vincent, this circuit eliminates the current distribution noise typical of pentodes and gives higher gain with less noise than comparable triodes. The grid pentodes are E180F-type 6SCH9P and 6SCH51P, new old stock originally used around the clock for amplifying high-frequency signals in telecommunication. A grid triode forms the impedance converter. Vincent's own Vimala power supply module powers the BestPentode stage.

Bass and treble controls use an additional gain block with 6SCH9P and 6SCH51P tubes and a Vimala module. A TONE button lets the signal bypass this section. The output resistance is 1 ohm, and two separate output resistors of 50 and 600 ohms are provided.

An integrated D/A converter is provided for the optical and coaxial inputs, and an Analog/Digital button switches between the analogue and digital inputs. Supported formats are WAV, FLAC, APE, LPCM, MP3, AAC, AC3 and WMA. The tubes are visible through an illuminated display window with a dimmer on the rear panel. A 230/110 V voltage selector and an automatic shutdown after about 15 minutes of non-use are included. The VRC-13 remote control, a Bluetooth antenna, a Toslink cable, a stereo RCA cable and a power control cable come in the box.

Pairing

A stereo power amplifier with RCA inputs is required. The matching power amplifier in the tubeLine is the SP-T700. Two pre-outs allow a second power amplifier to be connected.

Alternatives

The SA-T7 Diamond is the special edition of the SA-T7 tube preamplifier in Vincent's tubeLine.

Spezifikationen

  • Modellbezeichnung

    SA-T7MK

  • Analogeingänge (symmetrisch)

    N/A

  • Analogeingänge (unsymmetrisch)

    6

  • Analogausgänge (symmetrisch)

    N/A

  • Analogausgänge (unsymmetrisch)

    2

  • Verstärkung (dBu)

    N/A

  • Eingangsempfindlichkeit (mV)

    430

  • Ausgangsspannung (V)

    3

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    22 000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Ausgangspegel (symmetrisch) (dBu)

    N/A

  • Maximaler Ausgangspegel (unsymmetrisch) (dBu)

    N/A

  • Regelbereich der Lautstärke (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    10

  • Obere Grenzfrequenz +/- 3dB (Hz)

    100 000

  • Signal-Rausch-Abstand (SNR, unbewertet) (dB)

    >100

  • Klirrfaktor + Rauschen (THD+N) (%)

    <0.001

  • Abmessungen (mm)

    430 x 135 x 370

  • Gewicht (kg)

    8.5

  • Offizieller Link

Weitere Komponenten