The M7 Heritage (model code M7H) is a stereo tube preamplifier from Kondo Audio Note Japan with a phono amplifier unit and a line amplifier unit in one chassis. It is a new version of the classic M7, released in the late 1980s, which became known together with the ONGAKU power amplifier. Audio Note revised the circuit with updated crafts and technologies, and states that matching with modern systems is improved.
Key specs that matter
Two pairs of unbalanced RCA phono inputs present 47 kohm. Line inputs are three RCA pairs and one XLR pair at 50 kohm, and outputs are two RCA pairs and one XLR pair for loads over 20 kohm. All XLR connections are unbalanced. Gain is 25 dB from line in to line out and 63 dB from phono in to line out. Frequency response is 10 Hz - 280 kHz (+0 dB, -3 dB, 100 kohm load), RIAA deviation is ±0.3 dB (30 Hz - 20 kHz, excluding the low-cut filter), and THD is 0.07% (1 kHz, 1 V, line part). Noise is less than 0.15 mV on line and less than 5 mV on phono. Power consumption is 38 W, dimensions are 438 x 160 x 330 mm (W x H x D, excluding protrusions), and weight is 15 kg.
Engineering and use context
Its tube complement is two ECC803S and two 6072 in the phono unit, four 6072 in the line unit and one EZ81 (6CA4) rectifier. In the phono unit an SRPP circuit on the ECC803S, a 12AX7 type, forms the first stage. The 6072, a 12AY7 type, works as plate follower and cathode follower in the second and third stages. Audio Note built this unit as a module with the advantages of hand wiring and signal paths as short as on a PCB, and a decoupling capacitor is placed near the module.
Each line amplifier is also a module, with decoupling capacitors placed near the left and right channels separately. A plate follower is direct coupled to a cathode follower on the 6072, with an output impedance of 500 ohms and an 18 Hz cutoff frequency at a 20 kohm load.
Rectification is by tube, and the power transformer and chokes are arranged for minimum vibration. Ripple filter capacitors are separated from the decoupling capacitors, of which three kinds are used. A newly developed shunt type DC heater supply regulates the heater voltage within ±5%. Parts include Audio Note silver foil and electrolytic capacitors, silver lead resistors, SSW wiring, KSL-VzII interconnect, original RCA jacks, transformers and chokes, and a copper main chassis.
Pairing
Power amplifiers with an input impedance of 20 kohm or more are within the specified load. The matching power amplifier is the ONGAKU.
Alternatives
The Kondo G-1000i is a preamplifier in the current Audio Note range.