Hifiverse

Vorverstärker - Kondo Audio Note Japan G-70i

Beschreibung, Bilder, technische Daten und Spezifikationen

Kondo Audio Note Japan G-70i
Bildquelle - (c) Kondo Audio Note Japan

The G-70i is a stereo tube line preamplifier from Kondo Audio Note Japan and the revised form of the G-70, introduced in late 2010 at USD 33,968. Audio Note states that the G-70 has specifications to compete with solid-state preamplifiers. It has the same width and height as the GE-1 phono amplifier, which was designed as its companion.

Key specs that matter

Four pairs of unbalanced RCA inputs present 50 kohm, a value lowered from 100 kohm in April 2021. Two RCA output pairs are specified for loads over 20 kohm. Gain is 25 dB. Frequency response is 10 Hz - 240 kHz (+0 dB, -3 dB, with 100 kohm load), and noise is lower than 0.15 mV. Its tube complement is two 6072 and one 6X4 rectifier. Power consumption is 21 W. Dimensions are 303 x 160 x 408 mm (W x H x D, excluding protrusions), and weight is 17.5 kg.

Engineering and use context

Each channel of the main circuit is a plate follower direct coupled to a cathode follower, both on the 6072, for a low output impedance. In the line section the components are wired directly on a module board, for the shortest signal paths, and decoupling capacitors are arranged separately for the left and right channels to keep signal loops at minimal length. According to Audio Note, the circuit keeps its low-frequency performance down to 20 Hz into a solid-state amplifier with a low input impedance such as 20 kohm.

Rectification uses the 6X4 tube. Its power transformer design was fixed with attention to vibration countermeasures. Ripple filter capacitors total 400 µF, while decoupling capacitance in each channel is about 700 µF, made up of three capacitor types of 600 µF, 100 µF and 0.47 µF. A newly developed DC heater circuit is used.

Parts were chosen after listening tests and include a high grade volume control, original silver foil and electrolytic capacitors, silver lead resistors, three types of metalized film resistors, SSW silk silver wire, Ls-41 shielded cable, original RCA jacks and a copper chassis. The listed power cable is the ACz-AVOCADO.

Pairing

A separate phono amplifier is required for records, and the matching one is the GE-1. Power amplifiers with an input impedance of 20 kohm or more are within the specified load. The two output pairs allow a second power amplifier or a subwoofer.

Alternatives

The Kondo G-72i is another tube line preamplifier in the current Audio Note range.

Spezifikationen

  • Modellbezeichnung

    G-70i

  • Analogeingänge (symmetrisch)

    N/A

  • Analogeingänge (unsymmetrisch)

    4

  • Analogausgänge (symmetrisch)

    N/A

  • Analogausgänge (unsymmetrisch)

    2

  • Verstärkung (dBu)

    25

  • Eingangsempfindlichkeit (mV)

    N/A

  • Ausgangsspannung (V)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    50 000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    20 000

  • Maximaler Ausgangspegel (symmetrisch) (dBu)

    N/A

  • Maximaler Ausgangspegel (unsymmetrisch) (dBu)

    N/A

  • Regelbereich der Lautstärke (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    10

  • Obere Grenzfrequenz +/- 3dB (Hz)

    240 000

  • Signal-Rausch-Abstand (SNR, unbewertet) (dB)

    N/A

  • Klirrfaktor + Rauschen (THD+N) (%)

    N/A

  • Abmessungen (mm)

    303 x 160 x 408

  • Gewicht (kg)

    17.5

  • Offizieller Link