Hifiverse

Vorverstärker - Schiit Audio Freya 2

Beschreibung, Bilder, technische Daten und Spezifikationen

Schiit Audio Freya 2
Bildquelle - (c) Schiit Audio

The Freya 2 is a balanced line preamplifier from Schiit Audio that pairs four octal tubes with depletion-mode MOSFETs in a layout Schiit calls Fusion Architecture. It went on sale in autumn 2026 at USD 999 in black or USD 1,049 in silver, with four new-production tubes and the Forkbeard control module in the box. The chassis and transformers come from California, the circuit boards from Corpus Christi, and the units are assembled in San Antonio.

Key specs that matter

Five operating modes are available - passive with only the volume ladder in circuit, all tube, tube input, tube output and all solid state. Every active mode offers 0 dB or 12 dB of gain. Two XLR and three RCA inputs feed one XLR and two RCA outputs, all of which stay live unless the unit is muted. Input impedance is 10 kohm, and output impedance is 75 ohm single-ended and 150 ohm balanced. Frequency response holds within 0.05 dB from 20 Hz to 20 kHz. THD stays under 0.0007% at 1 V in solid-state low gain and under 0.003% in all-tube high gain, while A-weighted SNR referenced to 4 V exceeds 124 dB in all-tube low gain. Crosstalk is better than 90 dB. The case is 406 x 203 x 51 mm, the tubes add about 64 mm of height, and the weight is 5 kg. Consumption is 50 W with all four tubes running, 22 W in solid-state mode and 3.5 W in standby.

Engineering and use context

Volume runs through a hermetically sealed, relay-switched stepped attenuator built from discrete 0.5% thin-film resistors, with 128 steps of 0.625 dB. The fully linear supply uses 48 VA and 24 VA C-core transformers, a 300 V main rail, independently regulated 6 V DC heaters and a double series-regulated -30 V rail. The sockets accept 6SN7, 6N8S and 5692 tubes, others through adapters, though Schiit advises against the CV181. The Freya 2 detects which tubes are fitted and offers only the modes they allow, powers only the tubes in use and cuts the heaters on overcurrent or no-current faults. An IR remote covers volume, input, gain and mute, and the Forkbeard app for iOS and Android adds balance, tube health alerts and control of stacked Schiit units. Warranty is five years, with three months on tubes.

Pairing

Because XLR and RCA outputs work simultaneously, one pair can drive the main power amplifier while another goes to an active subwoofer. The 12 dB setting helps with power amplifiers of low input sensitivity, and Schiit's Vidar 2F, Aegir 2F and Tyr are matching partners. The Bifrost 3 DAC uses the same Forkbeard module.

Alternatives

The Saga 2 is the cheaper Schiit preamplifier, with four RCA inputs, a headphone output and solid-state circuitry only.

Spezifikationen

  • Modellbezeichnung

    Freya 2

  • Analogeingänge (symmetrisch)

    2

  • Analogeingänge (unsymmetrisch)

    3

  • Analogausgänge (symmetrisch)

    1

  • Analogausgänge (unsymmetrisch)

    2

  • Verstärkung (dBu)

    N/A

  • Eingangsempfindlichkeit (mV)

    N/A

  • Ausgangsspannung (V)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    10 000

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    10 000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    150

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    75

  • Maximaler Ausgangspegel (symmetrisch) (dBu)

    N/A

  • Maximaler Ausgangspegel (unsymmetrisch) (dBu)

    N/A

  • Regelbereich der Lautstärke (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    20

  • Obere Grenzfrequenz +/- 3dB (Hz)

    20 000

  • Signal-Rausch-Abstand (SNR, unbewertet) (dB)

    115

  • Klirrfaktor + Rauschen (THD+N) (%)

    0.003

  • Abmessungen (mm)

    406.4 x 203.2 x 50.8

  • Gewicht (kg)

    4.99

  • Offizieller Link

Weitere Komponenten