The ATC-3 is a stereo line-control amplifier with tubes from Air Tight, the brand of A&M Limited in Takatsuki, Osaka. It was released in 1998. According to Air Tight, it is based on the ATC-2 reference preamplifier and is housed in the ATC-1 chassis, whose power supply it uses. Its catalogue presents it as tube technology for digital sources and names SACD and DVD-Audio. In Japan it was listed at JPY 280,000 in standard form and at JPY 340,000 with the luxury volume option.
Key specs that matter
Tube complement is one 12AX7 (ECC83) and two 12AU7 (ECC82). Output voltage is 2 V rated and 15 V maximum. THD is below 0.01%, frequency response is 5 Hz - 100 kHz (±1 dB), and input sensitivity is 110 mV (output 1 V). S/N ratio is 90 dB (IHF-A weighted). Dimensions are 430 x 90 x 325 mm (W x H x D), and weight is about 8 kg. Its mains cord is detachable.
Engineering and use context
The line amplifier section uses an SRPP (shunt regulated push-pull) circuit with a reinforced buffer stage. Air Tight quotes power supply noise rejection, low output impedance and improved linearity of the 12AU7 output tubes for this circuit. In the two-stage negative feedback configuration a 12AX7 is the first stage and a 12AU7 the second, and both are self-biasing. Total gain of the line stage is 40 dB with 20 dB of negative feedback. A custom-selected coupling capacitor sets an output impedance below 200 ohms.
Inside the power supply a quick-recovery diode is the rectifier, a parallel-connected polypropylene capacitor is used, and a CR filter suppresses hum and noise. Wiring is done by hand, with printed boards used only in part. Parts include US-made polypropylene capacitors, 99.9999% (6N) copper wire, Belden wiring material and metal film resistors.
Its chassis is made from a single sheet of steel, bent and welded at the four corners and painted with several layers of high-gloss automotive enamel. On the front sit an extruded aluminium fascia, die-cut aluminium knobs and a gold nameplate. As an option, an Alps RK-501 high-precision potentiometer replaces the standard volume control.
Pairing
A power amplifier with a total input impedance above 47 kohms is required. Air Tight names its own tube power amplifiers as the match. A separate phono stage, such as the Air Tight ATE-3011, is required for a turntable.
Alternatives
The Air Tight ATC-7 is the current line-control amplifier of the brand, with two 12AX7 and two 12AU7 tubes, three RCA and two XLR inputs and a weight of 13.5 kg.