The XPA-9 Gen3 is a made-to-order nine-channel power amplifier from Emotiva, built on the modular XPA Gen3 platform. Its configuration combines five High-Powered Single-Channel Modules with two Stereo Modules, giving five high-power channels and four lower-power channels. Emotiva lists 5.1.4 and 7.1.2 Dolby Atmos or DTS:X systems, and 5.1 or 7.1 systems with extra speakers or zones, as its applications.
Key specs that matter
High-power channels are rated at 300 W RMS into 8 ohms (THD <0.1%) and 550 W RMS into 4 ohms (THD <0.2%) with one channel driven, 20 Hz - 20 kHz, and at 300 W and 490 W with two channels driven. Their broadband frequency response is 5 Hz - 80 kHz (+0/-2 dB), THD+N is <0.005% (100 W RMS, 1 kHz, 8 ohms), signal-to-noise ratio is >115 dB ref rated power, and input sensitivity is 1.71 V. Stereo Module channels deliver 65 W RMS into 8 ohms and 100 W RMS into 4 ohms with two channels driven. For them, broadband response is 50 Hz - 80 kHz (+0/-1.5 dB), THD+N is <0.02% (60 W RMS, 1 kHz, 8 ohms), signal-to-noise ratio is >105 dB and input sensitivity is 0.8 V. With all channels in use, the rating is 200 W RMS per channel into 8 ohms for the five mono channels. Gain is 29 dB and damping factor is >500 on every channel. Input impedance is 33 kohms balanced and 23.5 kohms unbalanced, and minimum recommended load is 4 ohms per channel. Maximum power consumption is 2,600 W. The chassis measures 432 x 203 x 483 mm (W x H x D, with feet) and weighs 24 kg.
Engineering and use context
All modules are independent, fully discrete, dual differential, high current Class A/B designs with a short signal path. A high-efficiency, audiophile-grade switch mode power supply with Optimized Class H topology powers them, and fault protection is microprocessor-controlled. Protection covers excessive operating temperature, shorted speaker connections and ground faults.
The heavy steel 4RU chassis has a milled aluminium faceplate. Each High-Powered module has one XLR and one RCA input, and each Stereo Module has two of each, with a metal toggle switch per channel selecting balanced or unbalanced. Further modules can be installed at the factory. A blue status LED per channel turns red on a fault, and mains operation is 100 - 250 V AC at 50/60 Hz, detected automatically. Emotiva gives a five-year warranty.
Pairing
An AV processor, preamplifier or AV receiver with preamp outputs is required. The high-power channels are intended for the front and side speakers, and the Stereo Module channels for surround or height speakers.
Alternatives
The XPA-5 Gen3 uses the same chassis with five High-Powered Single Channel Modules and two free module slots.