Hifiverse

Endstufen Stereo - Analog Domain The Isis M75P

Beschreibung, Bilder, technische Daten und Spezifikationen

Analog Domain The Isis M75P
Bildquelle - (c) Analog Domain

The Isis M75P is the stereo power amplifier of the Isis range by Analog Domain Audio GmbH, which Angel Despotov founded near Munich at the start of 2010. It carries the power section of the M75D integrated amplifier without its preamplifier, volume control and headphone amplifier, so an external preamplifier or an M75D sits ahead of it. The Dutch price in 2018 was EUR 19,600, and a Mk2 version followed later.

Key specs that matter

In stereo the M75P is rated at 2 x 250 W into 8 ohms and 2 x 400 W into 4 ohms (sine wave, rms). Bridged, it gives 500 W into 8 ohms and 1000 W into 4 ohms with music material, while the MK II manual lists 800 W into 4 ohms with a sine wave. Peak current is 50 A. Damping factor exceeds 1000 (1 kHz, 4 ohms, single-ended) and 500 in bridged mode. THD+N is below 0.001% (20 kHz BW, 8 ohms, nominal power) and below -95 dBr at 1 W into 4 ohms, and output noise is below 25 µV. Power bandwidth is 5 Hz - 50 kHz (2 ohms, THD below 0.1%). Voltage gain is +26 dB in stereo and +32 dB bridged. Input impedance is 20 kohm on XLR, 10 kohm on RCA and 5 kohm on the XLR5 direct input, and XLR input sensitivity is 2.25 Vrms. Analog Domain gives 440 x 454 x 123 mm (W x D x H, including feet and rear handles) and a net weight of about 25 kg.

Engineering and use context

Class AB+G is the operating mode. Its Excalibur output stage replaces the usual emitter follower, and Analog Domain combines it with proprietary DXDrive bias control, stating that the topology needs very little bias current for near class A performance. A tiered supply provides two voltages of each polarity, and a management circuit switches a rail to the higher voltage during peaks. Both channels run in inverse phase and draw from opposite supply poles, and the right channel input is wired inversely instead of passing through a phase inverter stage.

In bridge mode the M75P becomes a balanced single-channel amplifier, and a BRIDGE SOURCE switch selects the left or right input channel. On the rear panel a 3-position SOURCE switch selects the input, the RCA input has a +8 dB gain switch, and two sets of RCA and XLR sockets are wired in parallel for loop-through. This DC-coupled design has no capacitors in the signal path and has a thermal circuit breaker as mains switch. Standby draw is below 1 W and idle draw 20 W. Analog Domain grants a transferable ten-year limited warranty.

Pairing

A preamplifier with balanced or single-ended output is required, and tube preamplifiers need coupling capacitors. The XLR5 input links it to an M75D for bi-amping or for bridged stereo with each amplifier as one channel. Minimum rated load is 4 ohms in both modes.

Alternatives

Analog Domain lists no other stereo power amplifier, as its DX9 amplifiers are bridged single-channel designs.

Spezifikationen

  • Modellbezeichnung

    The Isis M75P

  • Eingangsempfindlichkeit (mV)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    50

  • Ausgangsleistung (8Ω) (W)

    250

  • Ausgangsleistung (4Ω) (W)

    400

  • Verstärkung (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    50

  • Obere Grenzfrequenz +/- 3dB (Hz)

    50 000

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    <0,001

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    >500

  • Abmessungen (mm)

    440 x 454 x 123

  • Gewicht (kg)

    25

  • Offizieller Link