The Reference 160S is a stereo tube power amplifier from Audio Research, the Minnesota company that has built tube electronics since 1970. Launched in 2019, it follows the REF160M monoblock of 2018 and carries over its feature set in one two-channel chassis, including dual GhostMeters that float in front of the eight KT150 output tubes. A black faceplate replaces the standard silver one to special order.
Key specs that matter
Rated output is 140 W per channel continuous from 20 Hz to 20 kHz, with 1 kHz THD typically 1% at 140 W and below 0.04% at 1 W. In Triode mode output is approximately 70 W per channel. Power bandwidth is 5 Hz - 70 kHz (-3 dB), and frequency response is 0.5 Hz - 110 kHz (-3 dB at 1 W). Input sensitivity is 2.4 V RMS balanced for rated output (25.5 dB gain into 8 ohms). Input impedance is 300 kohm balanced and 100 kohm single-ended. Output taps are 4, 8 and 16 ohms, and the damping factor is approximately 14. Overall negative feedback is 14 dB, slew rate is 13 V/µs and rise time is 2.0 µs. Consumption is 875 W at rated output, 700 W in Triode mode, 500 W at idle and 3.6 W off. Dimensions are 482.6 x 260 x 546 mm (W x H x D), 610 mm deep with handles and connectors, and net weight is 45.5 kg.
Engineering and use context
Four matched pairs of KT150 tubes form the output stage, and four 6H30 tubes are used in the gain stage, on a four-layer circuit board. A front-panel button switches between Ultralinear and Triode operation. Its proprietary auto-bias circuit is factory set and has no user-adjustable controls. About two minutes after switch-on it locks in the idle current at 65 mA per tube and then compensates continuously as the tubes age. In Tube Monitor mode an LED for each of the eight KT150s lights when that tube is operating properly.
Cooling is by two ultra-quiet fans mounted in the bottom cover, with a rear switch for high or low speed. An auto shut-off turns the amplifier off after two hours with no signal at the output and can be defeated from the rear panel. GhostMeter lighting has four brightness levels, including off. Balanced or single-ended input is chosen with a rear switch, and a 12 V trigger and an RS-232 port allow system control. Front and rear pairs of handles are mounted on the chassis.
Pairing
A preamplifier with balanced XLR or single-ended RCA outputs is required. The LS28SE line stage is the matching Audio Research preamplifier. Its 4, 8 and 16 ohm taps allow the output to be matched to the loudspeaker.
Alternatives
The Reference 80S is a lower-powered Audio Research stereo tube amplifier in the same Reference range.