The D-80 is a stereo tube power amplifier from Audio Research of Minnesota. Its design is taken directly from the Reference 80S stereo tube amplifier, in a more economical form, and its D prefix revives a model designation used on earlier Audio Research power amplifiers. It is built entirely in the company's Minnesota facility and tested twice.
Key specs that matter
Rated output is 80 W per channel continuous from 20 Hz to 20 kHz, with 1 kHz THD typically 1% at 70 W and below 0.04% at 1 W. Power bandwidth is 7 Hz - 68 kHz (-3 dB), and frequency response is 0.7 Hz - 94 kHz (-3 dB at 1 W). Input sensitivity is 1.4 V RMS balanced for rated output, for 25.5 dB of gain into 8 ohms, and input impedance is 300 kohm balanced. Speaker taps are provided for 4, 8 and 16 ohms. Output regulation is approximately 1.0 dB from a 16 ohm load to open circuit (damping factor approximately 8). Overall negative feedback is 15 dB, slew rate is 10 V/µs and rise time is 4.0 µs. Power consumption is 420 W at rated output, 221 W at idle and 3.6 W when off. Its chassis is 470 mm wide behind a 482.6 mm faceplate, 260 mm high and 470 mm deep (533 mm with handles and connectors), and net weight is 28.2 kg.
Engineering and use context
A pair of KT150 output tubes is used per channel, two matched pairs in total, and two 6H30 tubes make up the gain stage. Both channels are part of a fully balanced, differential signal path. Its output is also fully balanced and drives both legs of the loudspeaker. The D-80 is a full pentode design.
Audio Research gives the amplifier balanced XLR inputs only, as it expects most owners to use a preamplifier with XLR outputs. Polarity is non-inverting, with pin 2 positive on the balanced input (IEC-268). An auto-bias circuit adjusts the output tube bias continuously and in real time, compensating for line voltage and tube age. Mains versions are rated for 105-130 V at 60 Hz or 210-250 V at 50 Hz, and units for Japan run on 100 V at 50/60 Hz.
Pairing
A preamplifier with balanced XLR outputs is required. Audio Research line stages such as the LS28SE have balanced main outputs. The 4, 8 and 16 ohm taps allow the output to be matched to the nominal impedance of the loudspeaker.
Alternatives
The Reference 80S is the Audio Research stereo tube amplifier on which the D-80 design is based.