The MC275 is a 2-channel vacuum tube power amplifier from McIntosh Laboratory, now in its sixth generation. First released in 1961, it was discontinued in 1971 and came back in 1993 as a commemoration edition honouring McIntosh co-founder Gordon Gow. McIntosh equips the current version with its widest bandwidth output transformer design.
Key specs that matter
Power output is 75 W per channel into 4, 8 or 16 ohms with both channels operating, or 150 W into 2, 4 or 8 ohms in mono parallel mode, with a rated power band of 20 Hz - 20 kHz. Total harmonic distortion is 0.5% maximum from 250 mW to rated power (20 Hz - 20 kHz) and 0.25% or less at 1 kHz. Frequency response is 20 Hz - 20 kHz (+0, -0.5 dB) and 10 Hz - 100 kHz (+0, -3 dB). Signal-to-noise ratio is 105 dB below rated output (A-weighted), dynamic headroom 1.2 dB and damping factor greater than 22. Input sensitivity is 1.7 V unbalanced and 3.4 V balanced, with 47 kohms and 20 kohms input impedance. Its tube complement is three 12AX7A (input and phase inverter), four 12AT7 (voltage amplifier and driver) and four KT88 output tubes. Dimensions are 419 x 216 x 305 mm (W x H x D), and weight is 30.5 kg.
Engineering and use context
Both output transformers use the patented McIntosh Unity Coupled Circuit, the technology the company was founded on in 1949. Each has two bifilar wound primaries, one for the cathodes and one for the plates, and a secondary wound together with them. McIntosh specifies very close primary to secondary coupling, flat frequency response and wide power bandwidth for this winding. In the all-tube circuit only tubes amplify the signal. A regulated power supply with a large core power transformer and large capacitors supplies the tubes.
Sentry Monitor is fuse-less protection. It shuts the amplifier down on an output tube malfunction or shorted speaker wires, and the small tubes nearest a failed output pair light red. Tri-colour LEDs under the seven small tubes glow amber during warm-up and green when the amplifier is ready. Ceramic tube sockets have gold-plated contacts, and the output tube sockets have Air-Pipe cooling at their bases. Two gold-plated jumper bars are included for mono parallel operation. The chassis is polished stainless steel with a mirror finish, with gold-plated Solid Cinch speaker binding posts.
Pairing
A preamplifier with balanced or unbalanced outputs is required. Loudspeakers connect to the output tap that matches their nominal impedance. Power control input and output switch the amplifier and its tube illumination from a McIntosh preamplifier.
Alternatives
The former McIntosh MC2152 70th Anniversary is another 2-channel tube power amplifier from the brand.