Hifiverse

Endstufen Stereo - Kora CSA 270

Beschreibung, Bilder, technische Daten und Spezifikationen

Kora CSA 270
Bildquelle - (c) Kora

Kora's CSA 270 is a stereo power amplifier operating in pure Class A. The French brand was founded in 1990, closed in the early 2000s and was revived in 2017 by engineer Bruno Vander Elst, with production near Toulouse. Before the CSA series the range consisted of the TB140, TB200 and TB400 Class AB integrated amplifiers, the TA240 and TA480 power amplifiers, the PR140 preamplifier, the CD140 player, the DAC140 and a phono stage. Four CSA models were first shown at the Munich show in May 2025, and the CSA 270 is the small stereo version. The French launch price was EUR 19,800, and in the United States it sells for USD 24,999 and is built to order.

Key specs that matter

Rated output is 2 x 70 W into 8 ohms in pure Class A. Each channel has an RCA input (unbalanced, 47 kohms) and an XLR input (balanced, 20 kohms), its own sensitivity setting and its own pair of speaker terminals. Power comes from a linear supply with 400,000 µF of filtering. Dimensions are 420 x 440 x 260 mm and weight is 32 kg, in an aluminium and steel case finished in Mineral grey. This small chassis is shared with the CSA 1150 mono model, rated at 1 x 150 W.

Engineering and use context

Kora combines its Square Tube circuit with pure Class A operation and a highly filtered linear supply. This hybrid design combines tubes with audio transistors. In the output stage the transistors are biased in the middle of their characteristics and always operate in their linear zone, and the small CSA versions use 40 output transistors. Both supply voltages are fixed. With signal, the current through the transistors varies around the quiescent current, the push and pull devices change their current by the same amount, and only the difference reaches the loudspeaker. Power not sent to the speaker is dissipated as heat, so the unit warms up considerably at high Class A current and needs free air around it.

A rear CURRENT switch offers LOW, AUTO and HIGH. In the economical mode the quiescent current is halved, and AUTO moves the amplifier to nominal current when the signal requires full power. With the POWER switch on AUTO it turns on as soon as a signal is present at the input and goes to standby after more than one minute without one. The GAIN potentiometers can also balance the two channels. A slow pre-charge circuit fills the capacitor bank over a few minutes, and Kora gives peak mains currents of around 10 to 20 A.

Pairing

A preamplifier is required, and the matching Kora model is the PR140. The XLR inputs accept a balanced preamplifier.

Alternatives

The Kora CSA 2120 is the large stereo model, with 2 x 120 W into 8 ohms, 560,000 µF of filtering, a 420 x 660 x 260 mm case and a weight of 45 kg.

Spezifikationen

  • Modellbezeichnung

    CSA 270

  • Eingangsempfindlichkeit (mV)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    N/A

  • Ausgangsleistung (8Ω) (W)

    2 x 70

  • Ausgangsleistung (4Ω) (W)

    N/A

  • Verstärkung (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    N/A

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    N/A

  • Abmessungen (mm)

    420 x 440 x 260

  • Gewicht (kg)

    32

  • Offizieller Link

Weitere Komponenten